10
Dishwasher Features
Your Whirlpool dishwasher may have some or all of these features.
TargetClean™ Wash Area
The TargetClean™ wash area is located
at the back of the lower level rack.
NOTE:
You must select the TargetClean™
wash option to use this feature. Make
sure items do not interfere with the water
feed tube, spray arms, or TargetClean™
spray jets.
■
Load pans, casserole dishes, etc., in the back of the lower
dish rack with the soiled surfaces facing the TargetClean™
spray jets.
■
Only one row of items may face the TargetClean™ spray jets.
Stacking, overlapping, or nesting items will keep the
TargetClean™ spray jets from contacting all of the surfaces.
ANYWARE™ PLUS silverware basket
The ANYWARE™ PLUS silverware basket can be hung on
the door, the bottom rack, or placed inside the bottom rack.
To open the ANYWARE™ PLUS silverware basket
To unlock, grasp the front panel, pull up, and rotate 90° as shown.
Make sure the front panel is up all the way before rotating
.
To
unlock and rotate the front panel, grasp the front panel, as shown,
and pull it up and out.
NOTE:
Be sure the front panel of the silverware basket is
completely locked into place before pulling out the bottom
rack and before closing the dishwasher door.
To remove the basket from the door
1.
Grasp the silverware basket by the handle. Slide it toward
the top of the door.
2.
Lift the basket off the holding buttons.
To replace the basket in the door
1.
Set the silverware basket on the holding buttons.
2.
Slide the basket toward the bottom of the door until
it locks into place.
CONTROLS AND CYCLE STATUS
CONTROL
PURPOSE
COMMENTS
Press to start or resume a wash cycle.
If the door is opened during a cycle or the power is interrupted, the
S
tart/Resume button LED flashes. Cycle
will not resume until door is closed and
S
tart/Resume is pressed.
NOTE:
If
S
tart/Resume button is located on top of door, push door firmly closed within 3 seconds of pressing
S
TART/RE
S
UME. If door is not closed within 3 seconds,
S
tart/Resume button LED will flash, an audible tone
will be heard (on some top control models), and cycle will not start.
Press to cancel wash cycle.
Close the door firmly. The dishwasher starts a 2-minute drain (if needed). Let dishwasher drain completely.
Press and hold
S
TART/RE
S
UME for 3 seconds.
To follow progress of
your dishwasher cycle.
NOTE:
Indicators shown
are not available on
all models.
The Clean indicator glows when a cycle is finished.
If you select
S
ani Rinse option, when cycle is finished, the “
S
anitized” indicator glows.
If your dishwasher did not properly sanitize your dishes, the light flashes at the end
of the cycle. This can happen if the cycle is interrupted, or water could not be heated
to required temperature. The light goes off when you open and close door or
press CANCEL.
Door position
Rack position
Rack position side
Back of
dishwasher
PUSH
