7
STEP 3
STEP 4
NOTE:
For most water conditions, the factory setting will give
good results.
■
Check water hardness level to ensure no rings or spots on
your dishware before adding rinse aid or adjusting the factory
setting.
■
If you have hard water or notice rings or spots, try a higher
setting.
Turn the arrow adjuster inside the
dispenser by either using your fingers
or inserting a flat-blade screwdriver into
the center of the arrow and turning.
--
-
m
ax
fill
- -
-
-
- - - -
-
-
-
-
Select a Cycle (cycles vary by model)
See Cycle and Option Selections charts in the following section.
Heavier cycles and options affect cycle length.
Select Options (options vary by model)
See Cycle and Option Selections charts in the following section.
You can customize your cycles by pressing the options desired.
Start or Resume a Cycle
■
Run hot water at the sink nearest your dishwasher until the
water is hot. Turn off water. For best dishwashing results,
water should be 120ºF (49ºC) as it enters the dishwasher.
■
For models with controls on top of the door, select wash
cycle, options, and press START/RESUME before closing the
door. Push door firmly closed. The door latches automatically.
Select the wash cycle, options, and press START/RESUME or
press START/RESUME to repeat the same cycle and options
as in the previous wash cycle.
■
You can add an item anytime at the beginning of the cycle.
Open the door slowly and add the item. Close the door firmly.
Press START/RESUME.
