Whirlpool Refrigarator, Instructions For Use Manual

Page: 14 / 21

14
Before contacting After-Sales Service:
Switch the appliance on again to see if the
problem has been solved. If it has not, disconnect
the appliance from the power supply and wait for
about an hour before switching on again.
If, after performing the checks described in
the Troubleshooting Guide and switching the
appliance on again, your appliance still does not
work properly, contact the After-sales Service,
explain the problem.
Specify:
• the model and appliance serial number (stated
on the rating plate),
• the nature of the problem,
• the Service number (the number after the word
SERVICE on the data plate on the inside of the
appliance),
• your full address,
• your telephone number and area code.
Note:
The direction of door opening can be changed. If
this operation is performed by After-sales Service
it is not covered by the warranty.
AFTER-SALES SERVICE
Warning - this appliance must be earthed
Fuse replacement
If the mains lead of this appliance is fitted with a BS 1363A
13amp fused plug, to change a fuse in this type of plug use
an A.S.T.A. approved fuse to BS 1362 type and proceed as
follows:
1. Remove the fuse cover ( A ) and fuse ( B ).
2. Fit replacement 13A fuse into fuse cover.
3. Refit both into plug.
Important:
The fuse cover must be refitted when changing a fuse and if
the fuse cover is lost the plug must not be used until a correct replacement is fitted.
Correct replacement are identified by the colour insert or the colour embossed in words on the base of
the plug.
Replacement fuse covers are available from your local electrical store.
For the Republic of Ireland only
The information given in respect of Great Britain will frequently apply, but a third type of plug and socket is
also used, the 2-pin, side earth type.
Socket outlet / plug (valid for both countries)
If the fitted plug is not suitable for your socket outlet, please contact After-sales Service for further
instruction. Please do not attempt to change plug yourself. This procedure needs to be carried out by
a qualified technician in compliance with the manufactures instructions and current standard safety
regulations.
ELECTRICAL CONNECTION FOR GREAT
BRITAIN AND IRELAND ONLY