8
Mounting the Ice Maker
NOTE:
When using this kit to replace an existing ice maker or
valve, the new valve and the new ice maker from this kit must
both be used.
1.
Screw two 5/8" ice maker mounting screws into upper holes
present in left wall of freezer section. Leave head out
approximately 3/8" for the slot in the icemaker hanger to slip
over the screws. Remove phillips screw (A) if present and
discard.
2.
Determine which of the two provided jumper harnesses
mates with the connector housing in the back of your freezer.
A 5-pin housing requires the jumper with the matching 5-pin
plug (A). A 4-pin housing requires the jumper with the
matching 4-pin plug (B).
3.
Connect the jumper chosen in step 2 to the harness on the
ice maker. Confirm the locking fingers snap into place. Route
jumper over the guide (A) and through the wire clip (B) on the
side of the ice maker.
4.
Connect the other end of the jumper to the housing in the
back of your freezer, making sure the locking fingers snap in
place.
5.
Slide ice maker hangers over screws.
IMPORTANT:
Make sure the top of each screw touches the
bottom of the hanger on the ice maker (see illustration). This
ensures the ice maker is oriented correctly.
6.
Tighten down top mounting screws, making sure the hangers
remain flush against the screws as the screws are tightened.
Insert remaining mounting screw into bottom of ice maker
and tighten.
Note:
The top front screw is slightly lower than the rear
screw, so the ice maker should tilt slightly so that water flows
from the fill cup.
7.
Confirm water fill tube is aligned with the fill cup on the
ice maker. If needed, loosen mounting screws to correct
alignment of ice maker with fill tube, then repeat steps 5-6.
A Guide
B Clip
Screw locations
A
3/8"
3/8"
Determining the proper jumper
Align fill tube with cup
Keep hangers against screws while tightening
Mounting ice maker on top screws
A
B
X2
