Now start...
With washer in laundry area.
✔
Insert
washers
into inlet
hoses.
Pull yellow shipping strap
entirely out of washer.
Use later for drain hose
connection. Power cord is
attached to shipping
strap.
Shipping strap
must be removed
for rear leveling
legs to drop down.
Read and
then
remove
label.
Plug power
supply cord
into grounded
outlet.
Attach drain
hose to drain
connector.
Do Not tighten
nuts on front legs
until washer has
been leveled.
A
B
Attach
inlet hoses
to water
faucets.
D
Attach inlet
hoses to hot
and cold
water valves.
Cold water
inlet valve
Hot water
inlet valve
B
Secure
drain hose
to laundry
tub or
standpipe.
Use yellow
clamp to
connect rigid
and flexible
drain hose
sections.
F
C
C
C
A
G
E
E
E
Level washer.
Panel B
1.
Read, then remove label
that covers power supply cord.
4.
Insert a flat washer into each
end of the inlet hoses. Check
that washers are firmly seated in
couplings.
Check inlet hoses periodically.
Replace inlet hoses if you find
bulges, kinks, cuts, wear or leaking.
Replace inlet hoses after five years
of use.
3.
Pull firmly to remove the
other end of shipping
strap from the back of the
washer to release self-leveling
legs.
Save the shipping strap for use in
Step 17.
2.
Pull yellow shipping strap with two cotter pins
entirely out of washer. The power supply cord
will still be attached to shipping strap.
Pull the yellow shipping strap
completely out of the washer.
A
B
Preparation:
Inlet hose
connection:
(to washer)
Use new hoses and washers that came with your washer.
Check that
drain hose is
proper length.
coupling
washer
5.
Attach one hose to the hot
water (bottom) inlet valve first;
then other hose to the cold water
(top) inlet valve. Tighten couplings
by hand. Then use pliers to make an
additional two-thirds turn.
DO NOT OVERTIGHTEN; this could
cause damage to couplings.
Inlets are plastic.
Do Not strip or
crossthread.
2 cotter pins
shipping
strap
label
hot water
inlet valve
cold water
inlet valve
Remove yellow shipping strap.
SLIDE WASHER ONTO CARDBOARD OR
HARDBOARD BEFORE MOVING ACROSS
FLOOR.
Move washer close to its final location.
Excessive Weight Hazard
Use two or more people to move
and install washer.
Failure to do so can result in back
or other injury.
WARNING