Whirlpool HC338, Use, Care And Installation Manual

Page: 9 / 40

5
(1) Fans On/Off and Delay-off
Power Function
(2) Change the left and right fan
(3) Change the fan speed
(4) Auto Clean
(5) Light
Auto clean and Easy dismantle 2 in 1 cookerhood
Model:HC338
H
OOD
O
PERATION
water inlet
water tank
Excess water hole
cleaner/detergent
Water
(1) (2) (3) (4) (5)
- Turn on and off the fans.
- When auto clean or delay off is enabled, press this button to cancel.
Delay Off Function
- With the fans on or off, press and hold this button for 3 seconds. The 5
minutes delay off timer will start with one beep sound and the fans will
start according to the last memorized speed.
- The fans and light will automatically turn off after 5 minutes delay off with
two beep sounds.
- Press this button to change left and right fan, L&R
>
L
>
R.
- When auto clean is enabled, this button cannot functioned.
- When the delay off is enabled, still can change the left and right fan.
- Press this button to change the high and low speed.
- When the fans are off or the auto clean is enabled, this button cannot
operate.
- When the delay off is enabled, still can change the fan speed.
- No matter fans are on or off, press this button to enable the auto clean.
- The hood shall be cleaned by using hood cleaner/detergent. Please do not
use abrasive cleaner/detergent which will damage the machine.
- Cleaning Steps:
a. Mix the cleaner/detergent and water by pouring them to
the marked level of the provided water jug. (the cleaner/
detergent : water = 1:12). Pour the cleaner/detergent
mixture in the water inlet as shown in the picture.
b. If the cleaner/detergent mixture comes out from the
excess water hole down into the oil cup, it means that
inside water tank is full and no more shall be poured
into the water tank.
c. Press the Auto Clean ( ) button to start with one beep
sound.The fans will change to low speed for 3 seconds,
and then the water pump will operate for 10 seconds.
Then fans change to high speed and start cleaning for 25 seconds.
The auto clean process will end with two beep sounds.
d. Dirty oil/water will be flowed into the oil cup.
- When auto clean is enabled, press On/Off ( ) button to cancel at anytime.
- During auto clean process, please refill with water and press auto clean
( ) button to continue the process in case of inadequate water.
- Press this button to turn on and off light.
- The light can be operate independently, it only will turn off automatically
after 5 minutes delay off.