23
Removing the Impeller from the Wash Motor
The impeller is attached to the wash motor and can
be removed once the wash motor is removed from
the pump base.
1.
Place the end of a flat-bladed screwdriver
into the back of the wash motor to hold the
armature of the motor from turing while un-
screwing the impeller clockwise.
(Fig. 3-28)
Take care not to scratch or nick the motor
windings.
To Remove the Volute
1.
Align the arrow on the volute and the
locator triangle on the wash motor
frame as in Figure 3-29.
2.
Lift the volute from the wash motor.
Fig. 3-28
Fig. 3-29
Do not touch sealed surfaces on the
impeller or the volute. Contamination or
damage will cause premature failure.
Volute
SERVICING THE DOOR HINGE
To service the door hinge the dishwasher must
be removed from its installed position. Be sure
to:
• Disconnect power from the unit.
• Disconnect the water supply line from the
unit.
• Disconnect the drain line from the unit.
Once the side of the dishwasher is accessible:
1. Remove the outer door panel and console
from the dishwasher door.
2. Remove the door spring from the tension
adjustment at the bottom of the unit and then
remove the spring link from the door hinge
plate
(Fig. 3-30)
.
3. Using a pair of pliers, slightly bend the tab
on the door hinge plate to open the slot for
the hinge pin.
(Fig. 3-30, INSET- Arrow points
at tab)
.
INSET
Fig. 3-30
Hinge Pin
