10
NOTE:
If microwave oven does not need to be adjusted, skip
steps 7-9.
7.
If adjustment is required, rotate microwave oven downward.
Using 2 or more people, lift microwave oven off of mounting
plate, and set aside on a covered surface.
8.
Loosen mounting plate screws. Adjust mounting plate and
retighten screws.
9.
Repeat steps 3-6.
10.
With the microwave oven centered, and with at least one
person holding it in place, insert bolts through upper cabinet
into microwave oven. Tighten bolts until there is no gap
between upper cabinet and microwave oven.
NOTES:
■
Some upper cabinets may require bolts longer or shorter than
3" (7.6 cm). Longer or shorter bolts are available at most
hardware stores.
■
Overtightening bolts may warp the top of the microwave oven.
To avoid warping, wood filler blocks may be added. The
blocks must be the same thickness as the space between the
upper cabinet bottom and the microwave oven.
A. Bolts
For Roof Venting Installation Only
1.
Insert damper assembly through the cabinet cutout so that the
long tab of the damper assembly slides into the raised slot of
the damper plate. Then secure with one of the remaining
screws removed in Step 1 of “Rotate Air Deflector.”
NOTE:
The screw cannot be installed if the damper assembly is
not positioned as shown.
2.
Connect vent to damper assembly.
Complete Installation
1.
Install filters. Refer to the User Instructions for filter placement.
2.
Plug microwave oven into grounded 3 prong outlet.
3.
Reconnect power.
4.
Check the operation of microwave oven by placing 1 cup
(250 mL) of water on the turntable, and programming a cook
time of 1 minute at 100% power. Test vent fan and exhaust by
operating the vent fan.
5.
If the microwave oven does not operate:
■
Check that a household fuse has not blown, or that a
circuit breaker has not tripped. Replace the fuse or reset
the circuit breaker. If the problem continues, call an
electrician.
■
Check that the power supply cord is plugged into a
grounded 3 prong outlet.
■
See the User Instructions for troubleshooting information.
Installation is now complete.
Save Installation Instructions for future use.
A. Screw
B. Damper assembly
C. Long tab (inside raised slot)
D. Upper cabinet cutout
E. Damper plate
A
A B C
D E
A. Vent
B. Damper assembly (under vent)
A B
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
WARNING
