6
DAILY USE
1.
LOADING LAUNDRY.
•
Prepare the laundry, following the
recommendations given in the section “HINTS AND
TIPS”. - Open the door and load the laundry into the
drum, without exceeding the maximum load
capacities indicated in the
Programme Chart
.
•
Close the door, pressing until the latch
audibly locks, and check that there is no
laundry trapped between the door glass
and the rubber seal.
2.
OPEN THE WATER TAP
Check that the washer dryer is connected correctly
to the water mains. Open the water tap.
3.
SWITCHING ON THE WASHER DRYER MACHINE.
Press button
; the lamp
flashes slowly.
4.
SELECTING A PROGRAMME AND CUSTOMISING A CYCLE.
The following functions are possible with this appliance:
•
Wash only
•
Wash and dry
•
Dry only
Wash only
Select the required programme with the PROGRAMME
selector dial. The duration of the wash cycle is shown on the
display. The washer dryer machine automatically displays the
maximum temperature and spin speed settings possible for
the selected programme. Adjust the temperature and/or spin
speed settings if needed with the relative buttons.
•
Press button
“
Temp°C
”
to cycle through progressively
lower temperature settings until cold wash is set (“
- -
“)
shown on display.
•
Press button
“
Spin speed
”
to cycle through progressively
lower spin speed settings until the spin cycle is turned off
(“0” shown on display).
Pressing the button again sets the highest possible setting.
Select the required options (if necessary).
• Press the button to select the option; the respective button
lamp illuminates.
• Press the button again to cancel the option; the lamp
extinguishes.
!
If the selected option is not compatible with the
programme set, an error warning tone sounds and the
indicator lamp flashes three times. The option is not selected.
Wash and dry
To wash and dry a load with no interruption between the
wash and dry cycles, make sure that the load does not
exceed the maximum permissible drying load for the
selected programme
(
see the column “
Max. load for drying
cycle
” in the
Programme chart
).
1. Follow the instructions given in the paragraph “Wash Only”
to select and, if necessary, customise the required
programme.
2. Press
“
Drying settings
”
to select the required drying mode.
Two drying modes are available: automatic or timer.
-
Automatic drying with selectable levels:
In automatic drying mode, the washer dryer machine dries the
laundry until the set level of dryness is reached. Pressing
button
“
Drying settings
”
once automatically selects the
highest drying level available for the selected programme.
Press the button again to reduce the drying level.
The following levels are available:
Wardrobe
: laundry is completely dry and ready to be put
away in the wardrobe without ironing.
Hanger
: laundry is left slightly damp to minimise
creasing. Garments must be hung to air dry completely.
Iron
: garments are left reasonably damp to make ironing
easier.
- Timer drying mode:
Press button
“
Drying settings
”
repeatedly to set timer
drying mode. After cycling through all the automatic drying
levels, continue pressing button
“
Drying settings
”
until the
desired time is displayed. Values from 210 to 30 minutes are
settable.
To wash a load of laundry larger than the maximum
permissible load for drying
(
see the column “
Max. load
for drying cycle
” in the
Programme chart)
, remove a few
garments once the washing cycle has finished before starting
the drying cycle. Proceed as follows:
1. Follow the instructions given in the paragraph “Wash Only”
to select and, if necessary, customise the required
programme.
2. Do not include a drying cycle.
3. Once the washing cycle is finished, open the door and
remove a few garments to reduce the load. Now follow the
instructions for “Dry only”.
N.B.: always allow a cooling down period after drying before
opening the door.
When using the two preset cycles “Wash & Dry 45’” and “Wash
& Dry 90’”, it is not necessary to select and start a drying cycle.
Dry only
This function is used to simply dry a wet load washed
previously in the washer dryer or by hand.
1. Select a suitable programme for the laundry you want to dry
(e.g. select cotton to dry wet cotton laundry).
2. Press button
“
Dry only
”
to dry without a wash cycle.
3. Press
“
Drying settings
”
to select the required drying mode.
Two drying modes are available: automatic or timer.
- Automatic drying with selectable levels:
In automatic drying mode, the washer dryer machine dries
the laundry until the set level of dryness is reached. Pressing
button
“
Drying settings
”
once automatically selects the
highest drying level available for the selected programme.
Press the button again to reduce the drying level.
The following levels are available:
Wardrobe
: laundry is completely dry and ready to be put
away in the wardrobe without ironing.
Hanger
: laundry is left slightly damp to minimise
creasing. Garments must be hung to air dry completely.
Iron
: garments are left reasonably damp to make ironing
easier.
For more information on functions, a more detailed guide may
be requested or downloaded from the website following the
instructions given on the last page.
WWW
