Whirlpool CABINET DEPTHSIDE BY SIDEREFRIGERATOR, Use & Care Manual

Page: 15 / 32

15
5. With cartridge cap in the vertical position, push the
new filter cartridge into the base grille until it stops.
Rotate the cartridge cap clockwise to a horizontal
position.
6. RUN WATER THROUGH THE DISPENSER UNTIL THE
WATER RUNS CLEAR (about 2-3 gallons or 6-7
minutes). This will clean the system and clear air from
the lines. Additional flushing may be required in some
households.
NOTE: As air is cleared from the system, water may
spurt out of the dispenser.
Using the dispenser without the water filter
You can run the dispenser without a water filter cartridge.
Your water will not be filtered. If you run the dispenser
without a water filter cartridge, keep the cartridge cap and
replace it in the base grille for future use.
1. Remove the water filter cartridge (See “Changing a
water filter cartridge” earlier in this section.) Then slide
the cartridge cap off the end of the filter cartridge. DO
NOT DISCARD THE CAP.
2. With the cartridge cap in the vertical position, insert the
cap into the base grille until it stops.
3. Rotate the cartridge cap to a horizontal position.
NOTE: The cartridge cap may not be even with the
base grille.
Ordering replacement filters
To order more water filter cartridges, call 1-800-253-1301
and ask for accessory Part #4392857 or contact your
authorized Whirlpool dealer.
Ice Maker Storage Bin
To remove the ice bin:
1. Pull the covering panel out from the bottom and then
slide it back toward the rear.
2. Lift the wire shut-off arm so it clicks into the OFF (up)
position. Ice can still be dispensed, but no more can be
made.
3. Lift up the front of the storage bin and pull it out.
4. Empty the ice bin. Use warm water to melt the ice if
necessary. Never use anything sharp to break up the
ice in the bin. This can cause damage to the bin and
the dispenser mechanism.
5. Wash with a mild detergent, rinse well and dry
thoroughly. Do not use harsh or abrasive cleaners or
solvents.
6. When you replace the bin, make sure it is pushed in
all the way or the dispenser will not work. Then push
the wire shut-off arm down to the ON position to restart
ice production. Make sure the door is closed tightly.