17
AFTER-SALES SERVICE
Before contacting After-Sales Service:
1.
See if you can solve the problem yourself with
the help of the Troubleshooting guide.
2.
Switch the appliance on again to see if the
problem has been solved. If it has not, disconnect
the appliance from the power supply and wait for
about an hour before switching on again.
3.
If the problem persists after this course of
action, contact After-sales Service.
Specify:
The nature of the problem.
The model.
The Service number (the number after the word
SERVICE on the data plate on the inside of the
appliance).
Your full address.
Your telephone number and area code.
Note:
The direction of door opening can be changed. If
this operation is performed by After-sales
Service it is not covered by the warranty.
INSTALLATION
Install the appliance away from heat sources. Installation in
a hot environment, direct exposure to the sun or installation
near heat sources (heaters, radiators, cookers) will increase
power consumption and should therefore be avoided.
If this is not possible, the following minimum distances must
be respected:
30 cm from coal or paraffin stoves;
3 cm from electric and/or gas stoves.
Fit the spacers on the rear of the condenser positioned at the
back of the appliance.
To optimize appliance efficiency, leave a 5 cm gap above the
appliance and make sure that adjacent kitchen units are
sufficiently distanced to allow air circulation.
Install the appliance in a dry, well-ventilated place, and
ensure it is level, using the front adjustment feet if
necessary.
Clean the interior.
Fit the accessories.
Electrical connection
Electrical connections must be made in accordance with
local regulations.
Voltage and power consumption are indicated on the rating
plate inside the appliance.
Regulations require that the appliance is earthed. The
manufacturer declines all liability for injury to persons or
animals and for damage to property resulting from failure to
observe the above procedures and reminders.
If the plug and socket are not of the same type, have the
socket replaced by a qualified electrician.
Do not use extension leads or adaptors.
Disconnecting the appliance
It must be possible to disconnect the appliance by
unplugging it or by means of a two-pole switch fitted upline
of the socket.
3gb33005.fm5 Page 17 Wednesday, February 21, 2001 5:43 PM
Summary of Contents for ARC 0700
Page 4: ... ...
