INSTALLATION
GAS CONNECTION
•
The gas supply system must comply with local regulations.
•
You can find specific local regulations for some countries in the paragraph “Reference to Local Regulations”. If no
information concerning your Country is given, please ask details to your Installer.
•
The connection of the hob to the gas pipe network or gas cylinder must be made by means of a rigid copper or steel
pipe with fittings complying with local regulations, or by means of a continuous-surface stainless steel hose complying
with local regulations. The maximum length of the hose is 2 linear metres.
•
Before connecting the tube to the elbow fitting (
A
), interpose the
washer (
B
) supplied, in compliance with EN 549.
Attention: if a stainless steel hose is used, it must be installed so as not to touch any mobile part of the furniture.
It must pass through an area where there are no obstructions and where it is possible to inspect it on all its length.
•
After connection to the gas supply, check for leaks with soapy water.
ELECTRICAL CONNECTION
•
The electrical connections must comply with local regulations.
•
The data relevant to the voltage and power absorption are indicated on the rating plate.
•
The earthing of this appliance is compulsory by law.
•
The manufacturer cannot be held responsible for any injury to persons or animals or damage to property
arising from failure to comply with these requirements.
•
When the hob is installed, provide a single-pole circuit breaker with a contact separation of at least 3 mm.
•
If necessary, the electrical power cable must be replaced exclusively with a power cable having identical
characteristics to the original supplied by the manufacturer (type H05V2V2-F T90°C or H05RR-F).
This operation must be performed by a qualified electrician.
Assembly
1.
Position the clips (
A
) in the spaces provided on the hob trim (fig. 3) if not already positioned.
2.
Measure the centre point of the vertical sides of the cut-out (fig. 1)
3.
Fit the brackets (
C
) in the centre of the vertical sides, aligning the upper edge of the brackets so that they are flush with
the worktop surface (fig. 2).
4.
Fix the brackets with the 4 screws supplied (
B
) using the holes provided.
5.
Insert the hob in the cutout, making sure the clips (
A
) are secured in the spaces provided (fig. 4).
Earth
(yellow/green)
L
N
C
B
fig. 2
fig. 1
For
setting into a marble worktop
, contact the After-sales Service for the installation kit and necessary
instructions.
4812 310 19277 Installation kit for marble worktop.
ADJUSTMENT TO DIFFERENT TYPES OF GAS
If the appliance is intended to operate with a different gas from the gas type stated on the rating plate and orange sticker
applied on the top of the hob, change the injectors.
Remove the orange sticker and keep it with the instructions booklet.
Use pressure regulators suitable for the gas pressure indicated in the Product Description Sheet.
•
The gas nozzles must be changed by After Sales Service or a qualified technician.
•
Nozzles not supplied with the appliance must be ordered from After Sales Service.
•
Adjust the minimum setting of the taps.
Note: when liquid petroleum gas is used (G30/G31), the minimum gas setting screw must be tightened as far as
it will go.
Should you experience difficulty in turning the burners knobs, please contact the After Sales Service for the
replacement of the burner tap if found to be faulty.
REPLACING THE INJECTORS
(see the injector table in the Product Description Sheet)
•
Remove grids (A)
•
Extract burners (B)
•
Using a socket spanner of the appropriate size unscrew the injector (C)
•
Replace it with the injector suitable for the new type of gas.
Before installing the hob, remember to affix the gas calibration plate
supplied with the injectors in such a way that it covers the existing
information relating to gas calibration.
A
fig. 4
fig. 3
