Fig 3
Fig 4
1. The minimum distance between the support surfaces of the cooking pots on the cooker top and
the lowest part of the cooker hood must be at least 65 cm.
2. Remove all filter(s) (Fig.5) before installation.
3. Drill two φ8 holes in the wall according to point C.
（
Fig.2
）
4. Place the hook in the point A point B and fasten it with ST4X10 cross recess head screw.
（
Fig.2
）
5. Insert expansion pipe into the two holes, then punch ST4*40 expansion bolt into the expansion
pipe , do remember to leave over measure of 10cm .
6. Place the hook hole of chimney hood into the expansion bolt, and make sure that expansion bolt
is fully inserted into expansion pipe.
7. This model can be installed as filtered version with optional charcoal filters purchased from
manufacturers. Filters can be installed as Fig 4.
REMARKS
1. A straight, short pipe will allow the hood to perform efficiently.
2. Long duct, elbows and transitions will reduce performance of the hood. Use as few as possible.
Bigger pipe may need when using long duct.
