GB14
1.
Control panel.
2.
Grease filter.
3.
LEDs.
4.
Front panel.
Control panel
T1. Motor ON/OFF
Press key
T1
and the hood switches from OFF status to speed 1.
Press key
T1
during operation at any speed and the hood switches to OFF status.
T2. Speed timing
Speed timing is enabled by pressing key
T2
; the hood switches off at the end of the time.
Operation times are as follows:
Speed 1
- 20 minutes (LED 1 blinking)
Speed 2
- 15 minutes (LED 2 blinking)
Speed 3
- 10 minutes (LED 3 blinking)
Speed 4
- 5 minutes (LED 4 blinking)
Press key
T4
during timed operation and the hood exits timed mode and decreases the speed.
Press key
T3
and the hood exits timed mode and increases the speed.
Press key
T2
and the hood exits timed mode maintaining the set speed.
T3. Increase speed
Press key
T3
during operation and the motor speed increases from minimum to maximum.
The corresponding LEDs light up at each speed:
Speed 1
LED1
Speed 2
LED1 + LED2
Speed 3
LED1 + LED2 + LED3
Speed 4
LED1 + LED2 + LED3 + LED4
T4. Decrease speed
Press key
T4
during operation and the motor speed decreases.
T5. Lights ON/OFF
T6. Carbon filter signalling
Key
T6
lights up (red) after 160 hours of operation. This indicates that the carbon filter installed needs to be replaced.
To reset the signalling, keep key
T6
pressed for 4 seconds.
The signalling will stop and the hood will switch to OFF status.
IMPORTANT:
When using the hood in extractor version it is necessary to disable carbon filter signalling.
Deactivating carbon filter signalling:
Switch the hood to OFF status and keep key
T2
pressed for 4 seconds; a beep will sound.
Activating carbon filter signalling:
Switch the hood to OFF status and keep key
T2
pressed for 4 seconds; a beep will sound and key T4 will blink for 3 seconds.
IMPORTANT: Condensation may form on the front surface of the hood when cooking food with the hob switched on. In this case, clean the
surface of the hood with a damp cloth after cooking.
1
2
3
4
T1
T2
T3
T4
T5
T6
led 1
led 2
led 3
led 4
DESCRIPTION AND USE OF THE HOOD
