n
001
Whirlpool® is a registered trademark of Whirlpool, USA.
Your dishwasher may not work properly.
Before contacting the Service Centre check if the problem can be solved by going through the following list.
PROBLEMS
POSSIBLE CAUSES
SOLUTIONS
The dishwasher
won’t start or
does not respond
to commands.
The appliance has not been plugged
in properly.
Insert the plug into the socket.
Power outage.
The dishwasher starts automatically when the power returns.
The dishwasher door is not closed.
Vigorously push the door until you hear the “click”.
It does not respond to commands.
Switch off the appliance by pressing the ON/OFF button, switch it
back on after approximately one minute and reset the program.
The dishwasher
won’t drain.
The wash cycle has not finished yet.
Wait until the wash cycle finishes.
The drain hose is bent.
Check that the drain hose is not bent
(see
Installation
)
.
The sink drain pipe is blocked.
Clean the sink drain pipe.
The filter is clogged up with food
residues.
Clean the filter (
see
Cleaning the Filter Assembly
).
The dishwasher
makes excessive
noise.
The dishes are rattling against each
Position the crockery correctly
(see
Loading the Racks
)
.
An excessive amount of foam has
been produced.
The detergent has not been measured out correctly or it is not
suitable for use in dishwashers
(see
Filling the Detergent Dispenser
)
.
Do not pre-wash the dishes by hand.
The dishes are not
clean.
The crockery has not been arranged
properly.
Arrange the crockery correctly
(see
Loading the Racks)
.
The spray arms cannot rotate freely,
being hindered by the dishes.
Arrange the crockery correctly
(see
Loading the Racks
)
.
The wash cycle is too gentle.
Select an appropriate wash cycle using the Program Table.
An excessive amount of foam has
been produced.
The detergent has not been measured out correctly or it is not
suitable for use in dishwashers
(see
Filling the Detergent Dispenser
)
.
The cap on the rinse aid compart-
ment has not been shut correctly.
Make sure the cap of the Rinse Aid dispenser is closed.
The filter is soiled or clogged.
Clean the filter assembly
(see
Care and Maintenance
).
There is no salt.
Fill the salt reservoir
(see
Filling the Rinse Aid Dispenser
).
TROUBLESHOOTING
MAINTENANCE AND TROUBLESHOOTING GUIDE
For more information, maintenance procedures and trouble-
shooting, see the
Use and Care Guide
The
Use and Care Guide
can be obtained by:
• After-Sales Service; phone number see in warranty booklet.
• download from Whirlpool website: http://docs.whirlpool.eu
• use QR code
IEC 436
:
CONTACTING AFTER-SALES SERVICE
When you contact the After-Sales Service, you must
provide the codes shown on
the rating plate attached to
the left or right side inside the
door of the dishwasher. The
phone number is listed in the
warranty booklet or on the
website:
http://www.whirlpool.eu
TECHNICAL DATASHEET
The technical data containing the energy consumption data
can be downloaded from the Whirlpool website
http://docs.whirlpool.eu
EN
195139916.0
2
0
5
/2016
jk
- Xerox Fabriano
