Whirlpool 859991571480, Health & Safety, Use & Care And Installation Manuals

Page: 4 / 14

IMPORTANT : When the gas cylinder or gas
container is installed, it must be properly settled
(vertical orientation).
WARNING : This operation must be perfomed
by a qualified technician.
Use only flexible or rigid metal hose for gas
connection.
Connection with a rigid pipe (copper or steel)
Connection to the gas system must be carried
out in such a way as not to place any strain of any
kind on the appliance. There is an adjustable
L-shaped pipe fitting on the appliance supply
ramp and this is fitted with a seal in order to
prevent leaks. The seal must always be replaced
after rotating the pipe fitting (the seal is provided
with the appliance). The gas supply pipe fitting is
a threaded 1/2 gas cylindrical male attachment.
Connecting a flexible jointless stainless steel
pipe to a threaded attachment. The gas supply
pipe fitting is a threaded 1/2 gas cylindrical male
attachment. These pipes must be installed so
that they are never longer than 2000 mm when
fully extended. Once connection has been made,
make sure that the flexible metal pipe does not
touch any moving parts and is not compressed.
Only use pipes and seals that comply with
current national regulations.
IMPORTANT : If a staineless steel hose is used,
it must be installed so as not touch any moving
part of the furniture (e.g. drawer). It must pass
thorugh an area where there are no obstructions
and where it is possible to inspect it across its
entire length.
The appliance should be connected to the
main gas supply or to a gas cylinder in compliance
with the current national regulations. Before
making the connection, make sure that the
appliance is compatible with the gas supply you
wish to use. If it is not, follow the instructions
indicated in the paragraph “Adapting to different
types of gas”.
After connection to the gas supply, check for
leaks with soapy water. Light up the burners and
turn the knobs from max position 1* to minimum
position 2* to check flame stability.
Connection to the gas network or the gas
cylinder may be carryout using a flexible rubber
or steel hose, in accordance with current national
legislation
ADAPTING TO DIFFERENT TYPES OF GAS
(THIS OPERATION NEEDS TO BE CARRIED OUT BY
A QUALIFIED TECHNICIAN.)
In order to adapt the appliance to a type of
gas other than the type for which it was
manufactured (indicated on the rating label),
follow the dedicated steps provided after
installation drawings.
Adapting to different types of gas.
In order to adapt the oven to a type of gas other
than the type for which it was manufactured
(indicated on the label), follow these simple
steps:
Replacing the oven burner nozzle
1. Open the oven door fully.
2. Slide the bottom of the oven out.
3. Unscrew the burner fastening screws.
4. Remove screw (V) and then the oven burner.
5. Unscrew the oven burner nozzle using the
special socket spanner for the nozzles, or better
still a 7 mm socket spanner, and replace it with a
nozzle suited to the new type of gas (see Table 1).
6. Replace all the parts, following the steps
described above in the reverse order.