64
Error Code Appears in Display (for 2- and 3-digit displays) (cont.)
F# E# or F## E## code
other than as described
above appears in display
System error code.
Touch POWER once to clear the code. Then touch POWER
again to restart washer. If code appears again, call for service.
Unplug washer for 30 seconds; then plug back in.
Washer making error
beeps
Door has not been opened and
closed for at least three cycles.
This code may occur when the washer is first turned on.
Open and close the door to clear the display.
Washer beeps when
START/PAUSE is touched
Door not closed.
Close the door completely.
Clean Washer LED flashing
at end of wash cycle
(on some models)
The washer has run 30 wash cycles
and is indicating a reminder to run the
Clean Washer with affresh
®
cycle.
Run the Clean Washer with affresh
®
cycle. If the Clean Washer
with affresh
®
cycle is not turned on, the LED will stop flashing
at the end of a wash cycle after running three more regular
wash cycles. After 30 more wash cycles are completed, the
Clean Washer with affresh
®
LED will again flash at the end of
a wash cycle as a reminder.
TROUBLESHOOTING
If you experience
Possible Causes
Solution
Error Code Appears in Display (for 2- and 3-digit displays) (cont.)
“rL”
(remove load)
appears in display
Load detected in drum during Clean
Washer with affresh
®
cycle.
Remove items from washer drum and restart Clean Washer
with affresh
®
cycle.
First try the solutions suggested here or visit our website at
www.whirlpool.mx/service
or see the service contact sheet from your country located at the end of this guide.
Summary of Contents for 7MWFW5622HW
Page 79: ...79 NOTES ...