Whirlpool 6ADP 5656 WHM, Service Manual

Page: 2 / 16

S E R V I C E
08.08.2002 / Page 2 6ADP 5656 WHM Whirlpool Europe
Doc. No: 4812 718 18231 8542 656 53710 Customer Service
Technical data
Dimension
Height 85.0 cm
Width 59.7 cm
Depth 61.0 cm
Weight 58 kg
Electronic boards
Service boards see spare part list
Serial boards see on the boards itself
DUB 4619 724 06781
Programing of version and programmed control
board, see „Service“ and „Data set“ on rating
plate of inner door:
CB programmed
464783
Data set 464771
Basic control board, not programmed see on the
board itself
4619 724 17411
Succession of programs
Programs see program diagram
Succession A1a - A3a - A4a - A5b - A6a - A7a
Alarms
Refill rinse aid
Options
Zone washing
Delay function
Program information
Start indicator
Pre wash
Main wash
Drying
End
All programs will be locked after start. Changing
the program or finishing the program will be
possible only after pressing the start button for
longer then 1.5 sec. (Break by customer)
A switching off the appliance or unplug the
appliance for a while, this will frozen the program
step and later on, the program continuos on the
same position.
Exception: Switching off the appliance or unplug
the appliance during the drying phase, this will lead
directly to the end of the program.
Water Volume at alternating spray system
Volume at alternating spray system (same level
when selected zone washing as in the normal
programs)
Water Volume Level
Regeneration 0.3 l 15 mm
Back rinse 3x 1.0 l 60 mm
Prewash 3.9 l 120 mm
Main wash 3.2 l 118 mm
Intermediate rinse 1 3.2 l 118 mm
Intermediate rinse 2 3.2 l 118 mm
Clear rinse 3.2 l 118 mm
Safety/ overflow 8.5 l 141 mm
Measuring the level
Remove the coarse sieve, put in a measuring
meter into the sump, measure the hight of the
water level.
Detergent max.
Pre-wash 10 cm
3
Main-wash 40 cm
3
Rinse aid 135 cm
3
6 Dosage steps 1 - 6 ml
Water pressure
Inlet pressure 0.3 - 10 bar
Spray pump pressure 0.3 bar
Rotations
Spray pump motor 2800 RPM
Drain pump motor 3000 RPM
Spray arm lower 30 - 40 RPM
Spray arm upper 30 - 40 RPM
Spray arms, turning rhythm at alternating spray
system
Turning starts every time with the upper spray arm
Pre wash Lower arm ~3min, Upper arm ~1min
Main wash Lower arm ~3min, Upper arm ~5min
Intermediate rinse
Lower arm ~2min, Upper arm ~2min
Final rinse Lower arm ~2min, Upper arm ~2min
Service Test program
Lower arm ~30sec, Upper arm ~30sec
Remark: When switching of the main switch or
interrupt the mains during the Test Program runs,
then the alternating of the spray arms change in
the test program to the rhythm of main wash 5/3
min.