A.
Install vent
system
(new
installation)
B.
Prepare dryer
1.
Put on safety
glasses and gloves.
3.
Connect exhaust vent to hood.
(Exhaust vent MUST fit inside hood.)
Secure vent to hood with 4" clamp.
4.
Run exhaust vent to dryer location.
Use the straightest path possible. (See Panel
C.) Avoid 90° turns. Use clamps to seal all
joints.
1.
Remove tape from dryer cabinet. Open
dryer door and remove tape from dryer drum.
(Not all dryer drums are taped.) Remove drying
rack, if included. Turn dryer drum
counterclockwise to make sure all tape was
removed. Wipe drum with damp cloth to
remove any dust.
2.
Take two
cardboard corners from
dryer carton and place
them on floor in back
of dryer. Firmly grasp
body of dryer and
gently lay it on its back
on the cardboard corners.
diamond
marking
3.
Start to screw legs into holes by hand.
Use an adjustable wrench or 1" hex-head
socket wrench to finish turning legs until you
reach the ridge with the diamond marking.
4.
Stand dryer up on cardboard
or hardboard.
Now start installation
(If installing washer and dryer, install dryer first.)
✔
SLIDE DRYER ONTO
CARDBOARD OR
HARDBOARD BEFORE
MOVING ACROSS FLOOR
TO PREVENT FLOOR
DAMAGE.
See installation steps for details.
B.
Install feet.
D.
Check that
dryer is level.
F.
Connect
vent to
dryer.
E.
Remove red cap.
Connect gas supply to
dryer. Check for leaks.
A.
Install vent system.
G.
Check operation.
C.
Change door
swing.
B.
Remove tape.
2.
Install exhaust
hood. Use caulking
compound to seal exterior
wall opening around
exhaust hood.
Panel D
Excessive Weight Hazard
Use two or more people to move and
install dryer.
Failure to do so could result in back or
other injury.
WARNING
