7
SinterPro
Furnace Operator’s Manual
12. Locate plastic bag containing 8 screws taped to the
inside of the Accessory box lid.
13. Mount white metal perforated lid with 8 screws
provided.
14.
Save all packaging/shipping materials
in case
of return/repair. The Customer is responsible for
re-packaging the furnace like it was received.
The
furnace must be returned in original carton
to
prevent damage. Failure to retain packaging will incur a
charge for a new carton plus shipping of empty carton.
15. Remove the oven from the shipping pallet following the
procedure pictured below:
CAUTION: THE OVEN WEIGHS 132 LB/60 KG.
LIFTING AND PLACEMENT OF THE OVEN IS A SAFE
PROCEDURE WHEN PERFORMED WITH FOUR (4)
PERSONS. THE PROVIDED LIFT STRAPS (ORANGE)
HAVE 3 LOOPS EACH. USE THE LOOP BEST SUITED
FOR YOUR HEIGHT IN ORDER TO USE YOUR LEGS TO
LIFT (NOT YOUR BACK). PLACE THE LOOP OVER YOUR
FOREARM UP TO THE ELBOW, THEN USE THE SAME
HAND PLACED ON THE OVEN TO STEADY THE LOAD.
• Place the SinterPro on a
non-flammable
, level surface
capable of supporting 200 lb. / 90 kg. The surface
should be high enough to allow easy access to the
muffle cavity for loading and unloading the muffle.
• Leave at least 12 in. / 31cm of
unobstructed air
space
around all sides and the rear of the furnace for
ventilation.
• Make sure that there is at least
36 in. / 92 cm of free
air space
above the top of the SinterPro cabinet for
ventilation.
•
The SinterPro Oven should not be placed in such
a way as to obstruct access to the AC Mains
disconnect to the oven in case of an emergency.
1
Fold out straps (4)
3
Place same hand on oven to steady
2
Each person (4) place arm through loop
up to elbow
4
After placement, tilt oven back to remove
straps and save with the rest of material
FOUR persons required to lift the unit onto work surface. (60kg / 132 lb)
5
Placing the furnace
CAUTION! DO NOT LIFT BY
FRONT PANEL OR DAMAGE
WILL OCCUR!
