Page 3
FRONT OF VEHICLE
RADIA
TOR HOSE
RADIATOR
DRIVERS SIDE
Fig. 1
Fig. 3
Speaker attaches to
bracket as shown
The top view of the bracket
shows which holes to use
for this application
Top view of bracket
Mounting area shown with Battery
and tray plus air filter and filter
housing removed. The siren will
mount in this area.
Fig. 2
Use these holes for this
application.
MOUNTING
AREA
FIG. 1
Shown with front grill removed
5/16 SPLIT
LOCK
WASHER
FIG. 2
5/16 - 18
1/2" DIA.
HEX NUT
5/16 - 18 X 1
HEX HEAD BOLT
Speaker attaches
to bracket as shown
Top view of bracket
Installation / 2004-05 Dodge Durango:
1. First you will have to remove the grill. To remove the grill, you first
have to remove both headlight assemblies. Refer to your vehicle
owners manual for the proper procedure for both.
2. The speaker bracket will mount to the side of the support brace (on
the passenger side) that is indicated in Figure 1 below.
3. Place the bracket onto the mounting area in the exact position it will
be mounted, then using the bracket as a template mark the 2
mounting holes off onto the mounting surface.
4. Secure the speaker to the mounting bracket. An SA314 is shown. See
page 2 for an SA315.
5. Drill the 2 mounting holes using a drill bit sized for a 5/16 - 18 hex
head bolt and secure the bracket (with speaker) onto the mounting
area with the supplied mounting hardware.
6. Extend the WHITE (Positive) and BLACK (Negative) speaker wires to
your siren amplifier and connect as shown in the amplifiers
instructions and replace the grill you removed in step 1.
Installation / 2001 Ford Taurus:
READ BEFORE INSTALLING:
The speaker will mount in the area
usually occupied by the air bag system. If your vehicle is equipped
with A.B.S. you can not mount the speaker in this location.
For this application, the speaker will mount under the battery tray. First
you will need to remove the battery and tray, and the air filter and housing
(Fig. 2). The speaker bracket will mount to the drivers side of the engine
compartment, on the side wall.
1. Disconnect the ground on the battery, remove the battery and tray
and then remove the air filter and housing.
2. Attach the speaker to the bracket (Fig. 1). An SA314 is shown. See
page 2 for an SA315.
3. Position the bracket (with speaker) onto the mounting area. Do not
position it so far forward that the speaker is muffled. Be sure the
bracket doesn’t interfere with any existing vehicle components. Using
the bracket as a template, mark the mounting surface where the
mounting screws will be located.
Note: Do not allow the new mounting hole locations to be directly
adjacent to any existing holes.
4. Remove the speaker from the bracket. Using the self-tapping screws
and washers supplied, mount the bracket onto the vehicle.
Note: You will need to drive the self tapping screws in with a socket
attached to a drill.
5. Remount the speaker to the bracket making sure that the speaker
wires exit the bottom for proper drainage .
6. Extend the WHITE (Positive) and BLACK (Negative) speaker wires to
your siren amplifier and connect as shown in the amplifiers
instructions.
