Page 2
Fig. 5
Fig. 3
Fig. 4
Wire
Tie
Micro-Edge
Mounting
Bracket
Extension
Flange
Mirror
Bracket
U-Bolt
Fig. 1
Mounting the Micro-Edge Strobe:
IMPORTANT! The lightbar should be located a
minimum of 16" from any radio antennas!
Two Whelen Micro-Edge Strobe lights are
included in this lighting system. The mirror mount
brackets shown are purchased seperately. (See
parts list) Begin the mounting procedure by
loosely assembling the mounting bracket (Fig.1).
Position this partial assembly on the mirror
bracket as shown in Fig. 2. Mount the assembly to
the mirror bracket using the U-Bolt hardware
supplied with the brackets (Fig. 3). Insert the
mounting bolt on the Micro-Edge through the hole
provided in the extension flange. Secure as
shown in Fig. 3. Adjust the bracket assembly until
the Micro-Edge is properly aligned and tighten the
bracket bolts firmly. Repeat entire procedure for
the remaining door.
Fig. 2
Wiring the Micro-Edge Strobe:
The Micro-Edge harness cable must now be routed to the power supply. The path the
harness cable follows will vary, depending upon where the power supply has been
mounted. If the power supply has been mounted against the rear cab wall, the path would
be:
1.
Secure harness cable to Micro-Edge mounting bracket with heavy-duty wire ties (Fig.
4)
2.
Now have the harness cable follow the factory mirror bracket to the point where the
bracket meets the vehicle door. Secure the cable with heavy-duty wire ties.
3.
Remove the interior door panel. When you are sure that no door components will be
damaged, drill a hole in the door just below the point where the factory mirror bracket
connects to the door. Insert a rubber grommet to prevent water leakage.
4.
Insert the harness cable through the hole and route it towards the door’s hinge panel.
Drill a hole in the hinge panel and insert the harness cable.
Be sure that the cable
does not interfere with the movement of any door or window components
(Fig. 5).
5.
Route the cable into the cab through the kick panel and then under the rocker panel
molding toward the back of the cab. Make sure that the
harness cable does not bind
up when the door is opened and closed.
IMPORTANT
: The outer surfaces of this light may be cleaned with mild soap and water.
Use of any other chemicals may void product warranty. Do not use a pressure washer.
