Page 2
IMPORTANT:
Installation will require the installer to select a flat
mounting surface sufficient to accommodate the physical
dimensions of this light. Also keep in mind that the metal heat sink
will get warm, so it should have some clearance for radiant
cooling. Wire the light using the diagram below.
Installation
1.
Cut a 7.29 inch diameter clearance hole into the mounting
surface.
2.
Using the wiring diagram shown below, connect the wires of
the light to their appropriate designation.
NOTE: Be sure to
follow the fusing guidelines shown. If Low Power is not
used, insulate the unused VIOLET wire.
BLACK
WHITE
VIO
SP/DT Switch (Center Off)
To +12VDC
(fuse @ 3A)
To Ground
Low Power
High Power
Traditional Dimming:
Connect the WHITE and VIOLET wires to a Single
Pole / Double Throw (Center Off) Switch (customer
supplied) as shown. Fuse this switch @ 3A. Connect
the BLACK wires to Chassis Ground.
Optional Mounting:
Permanent mounting is possible if your
flange was ordered equipped with 4
mounting holes in the flange. Using the
flange as a template, mark the 4
mounting hole locations. Remove the
flange and drill appropriately sized
mounting holes, based on the thickness
of the mounting surface and the #10
mounting screws provided. Secure the
light using the hardware provided.
Wiring Diagram
1.24"
RETENTION
CLIP
MOUNTING
SURF
ACE
MOUNTING
SURF
ACE
7.29"
8.60"
Optional
Mounting
Holes
Waterproof butt splices and/or connectors are required if that
connection could be exposed to moisture. Any unused wires
must be sealed (waterproofed) to prevent moisture infiltration.
3.
Bend the retention clips forward as shown. Insert the light into
the mounting hole allowing the retention clips to snap back
against the mounting surface, securing the light.
Operation:
When wired as shown, the light will operate as follows:
Ap12VDC to the High Power WHITE wire (via the SP/
DT switch) will activate the light at full intensity (100%).
Ap12VDC to the Low Power (VIO) wire (via the SP/DT
switch) will activate the light at reduced intensity (10%).
