Page 4
3.
With the battery now accessible, remove it from the housing and
disconnect the Red and Black wires from the battery terminals.
IMPORTANT! The label on the interior mounting plate lists the
batteries that may be used with this product. Do not install any
battery other than what is listed on this label.
4.
To install a battery, connect the RED wire to the POSITIVE (+)
battery terminal and connect the BLACK wire to the NEGATIVE (-)
battery terminal.
CONNECTING THE WIRES TO THE WRONG
TERMINAL COULD CAUSE PERMANENT DAMAGE TO THE
BATTERY AND VOID THE WARRANTY!
Return the battery to its
installed location.
5.
Route the harness connector through its opening in the Interior
Mounting Board. Position the Board in its original mounting
location, making sure not to pinch any wires. Secure using the
original hardware removed in step 2.
6.
Connect the harness plug to the connector on the bottom cover,
position the cover in its original mounting location and secure
using the original hardware removed in step 2.
7.
Before reinstalling the bottom cover, make sure that the gasket
seal is properly positioned and not twisted. Position the cover onto
the housing and secure it to the housing using the original
hardware removed in step 1.
8.
Place the LA28 onto its base and allow it to fully charge before
returning it to service.
9.
If you are replacing the battery verify the proper dip switch
position:
WARNING: USE OF ANY OTHER BATTERY WILL PERMANENTLY
DAMAGE THIS PRODUCT
Attention!
If for any reason it becomes necessary to ship the LiFe battery,
whether installed in the LiFe Light or not, there are critical shipping
guidelines and procedures that need to be strictly followed.
Contact your shipping company for their specific packaging and
labeling requirements regarding the transportation of “Lithium Iron
Phosphate” batteries.
ON
1 2
-LiFePO4 BATTERY (ON,ON)
ONLY REPLACE WITH:
K2 ENERGY #K2B12V10EB
ON
1 2
-STANDARD BATTERY (OFF,ON)
(LEAD ACID)
IMPORTANT! When the battery has reached the end of its usable life, it is important that it be disposed of safely and properly.
Contact your local officials for Lithium Iron Phosphate (LiFePO4) or lead acid battery disposal guidelines and battery recycling
locations for your area.
M
O
D
EL
P
S-
12
70
F1
12
Volt 7.0 Amp. Hr.
W
arning
:
Ri
sk of f
i
r
e
,
e
xplos
i
on, or burns.
Do not d
i
sass
e
mbl
e
, h
e
at abov
e
60 C, or
i
nc
i
n
e
rat
e
.
Re
charg
e
abl
e
S
e
al
e
d
Le
ad-Ac
i
d Batt
e
ry
DC pow
e
r, constant voltag
e
charg
e
Cycl
e
us
e
:
1
4.4 -
1
5.0V(
2
0 C)
Standby us
e
:
1
3.5 -
1
3.
8
V(
2
0 C)
In
i
t
i
al curr
e
nt:
2
.
1
A MAX
8
0
1
3340
0
1
000
S
e
al
e
d
Re
charg
e
abl
e
Batt
e
ry
1200
7
0260211
Sealed Rechargeble Battery
