Page 2
IMPORTANT! It is the responsibility of the installation technician to make sure that the installation and operation of this product will not
interfere with or compromise the operation or efficiency of any vehicle equipment!
IMPORTANT AIR BAG WARNING! Do not install this product or route any wires in the air bag deployment zone of your vehicle. Equipment
mounted or located in air bag deployment zones will damage or reduce the effectiveness of the air bag, or become a projectile that could cause
serious personal injury or death. Refer to your vehicle owners manual to learn the air bag deployment zones for the vehicle. The User/Installer
assumes full responsibility to determine proper mounting location, based on providing ultimate safety to all passengers inside the vehicle.
Installation:
IMPORTANT! The lightbar should be located a
minimum of 16" from any radio antennas!
1.
On the rear deck, locate the 2 outboard caps
covering the child restraint strap holders. Remove
the plastic covers to access the tether strap
holders (Fig. 1).
2.
Install the 2 mounting brackets as shown in Fig 2. It
is important that these brackets be positioned so
that the housing rests flatly on top of them.
Be
sure to tighten the mounting hardware firmly.
3.
Secure the lightbar to the mounting brackets as
shown using the provided hardware. Confirm that
the unit is level and clears the 3rd brake light.
4.
Route the input cable to your control head (refer to
the installation manual included with your control
head for important mounting and wiring
information). It is left to the installation technician's
discretion to select a path for this cable that will
both protect it from possible damage and not
interfere with the operation of any other vehicle
components or equipment.
IMPORTANT!
When routing the lightbar cable, it is left
to the installation technician's discretion to select a path
for these cables that will both protect the cables from
possible damage and not interfere with the operation of
any other vehicle components or equipment. Refer to
the instructions included with your switches for switch
wiring information.
A windshield seal is included and should be installed to
eliminate vibration against the rear glass.
WARNING! All customer supplied wires that
connect to the positive terminal of the battery must
be sized to supply at least 125% of the maximum
operating current and FUSED at the battery to carry
that load. DO NOT USE CIRCUIT BREAKERS WITH
THIS PRODUCT!
Scan-Lock (WHT)™
TO CYCLE THROUGH ALL PATTERNS:
Apply +12 volts to the WHT wire for less than 1 second and release to cycle forward. Apply +12 volts to the
WHT wire for more than 1 second and release to cycle backward.
TO SET A PATTERN AS DEFAULT:
When the desired pattern is displayed, allow it to run for more than 5 seconds. The lighthead will now display
this pattern when active.
TO RESET TO THE FACTORY DEFAULT PATTERN:
Turn off power, apply +12 volts to the WHT wire, then turn power on.
A normally open momentary switch can be used to control Scan-Lock operation.
Low Power Operation (ORG)
NOTE: Low Power is not available with units equipped with end flashers
FOR LOW POWER OPERATION:
Apply +12VDC to the ORG wire. The unit will continue to operate in Low Power mode until this voltage is removed.
A Single Pole / Single Throw switch can be used to control Low Power operation.
IMPORTANT! Before returning the vehicle to active service, visually confirm the proper operation of this product, as well as all vehicle
components/equipment.
3RD BRAKE
LIGHT
Existing bracket
for tether strap
holder (Infant
car seat)
INSIDE OF
TRUNK
REAR
DECK
Mounting
Bracket
(Qty. 2)
1/4-20 x 5/8” Hex Bolt
1/4” Internal Tooth Lockwasher
1/4” FLAT WASHER
REAR
WINDOW
FIG. 2
CHILD
RESTRAINT
BRACKET
CHILD
RESTRAINT
BRACKET
FIG.1
TRUNK LID
REAR DECK
PACKAGE TRAY
ROOF
REAR
WINDOW
