Page 2
8 X 3/8 Phillips Pan Head
Sheet Metal Screw (2)
#8 Internal Tooth
Lock Washer (2)
Microphone Clip
Installing the Mounting Clip:
Using the supplied mounting hardware, secure the mounting clip in a convenient
location within easy reach.
Caution:
Permanent mounting of this product will require drilling. It is absolutely
necessary to make sure that no other vehicle components could be damaged by this
process. Check both sides of the mounting surface before starting. If damage is likely,
select a different mounting location.
IMPORTANT! It is the responsibility of the installation technician to make sure that
the installation and operation of this product will not interfere with or compromise the
operation or efficiency of any vehicle equipment! Before returning the vehicle to
active service, visually confirm the proper operation of this product, as well as all
vehicle components/equipment.
Installing the labels into the buttons:
•
For easy installation, put the label in place on the controller and then snap the button in over the top.
•
You must snap the square buttons in with the
clips facing the side of the controller. All other
buttons can only be snapped in one way.
•
Refer to the on-line help provided with the
software for programming procedures.
Label
3
1
Clips on square
buttons must face
side of controller
before snapping in.
PB
1
Pust to Talk
On/Off
PB
6
PB
9
PB
12
PB
7
PB
10
PB
13
PB
8
PB
11
PB
14
PB
4
PB
2
PB
5
PB
3
