P82030 K
Sheet 1 of 17
273 Branchport Avenue
Long
Branch,
NJ
07740
Thank you for using our products.
(800) 631-2148
www.wheelockinc.com
INSTALLATION INSTRUCTIONS
MODEL TPI-100
TELEPHONE PAGING RING START INTERFACE
Use this product according to this instruction manual. Please keep this instruction manual for future reference.
APPLICATION INFORMATION:
Wheelock Inc. manufactures high quality telephone products. The installation of this product must conform to the following
instructions.
IF ANY WORDS OR LETTERS APPEAR ON THE PRODUCT INDICATING A PARTICULAR USE, THE PRODUCT
MUST BE USED ONLY IN THE MANNER SO INDICATED. THE INSTALLATION OF THIS EQUIPMENT SHOULD ONLY BE
UNDERTAKEN BY QUALIFIED PERSONNEL. FIELD ADJUSTMENT, REPAIR OR MODIFICATION OF THESE SIGNALS SHOULD
NOT BE ATTEMPTED
. Malfunctioning units should be returned for factory repair or replacement in accordance with Wheelock
Inc.'s published terms and conditions. Contact Wheelock Inc., 273 Branchport Ave., Long Branch, NJ, 07740.
NOTE
:
All
CAUTIONS
and
WARNINGS
are identified by the symbol
. All warnings are printed in bold capital letters.
FCC REGULATIONS
-
This equipment complies with Part 68 of the FCC Rules. The label affixed to this product contains, among other
information, the FCC Registration Number and the Ringer Equivalence Number (REN) for this product. This information
must be provided to the telephone company if requested.
-
The REN is used to determine the quantity of devices which you may connect to your telephone line and still have all of
those devices ring when your telephone number is called. In most, but not all areas, the sum of the REN's of all devices
connected to one line should not exceed five (5.0). To be certain of the number of devices that you may connect to your
line, contact your local telephone company.
-
This equipment should not be used on coin telephone lines. Connection to party line service is subject to state tariffs.
-
If trouble is experienced, disconnect this equipment from the telephone line to determine if it is causing the malfunction. If
the equipment is determined to be malfunctioning, its use shall be discontinued until the problem has been corrected.
-
Should the equipment cause harm to the telephone network, the telephone company shall, if possible, notify the customer
that temporary discontinuance of service may be required; however, where prior written notice is not possible, the
telephone company may temporarily discontinue service without notice, if such action is necessary under the
circumstances. The telephone company may make changes in its communication facilities, equipment and operations
procedures, where such action is reasonably required in the operation of its business and is not inconsistent with the rules
and regulations of the Federal Communications Commission.
INDUSTRY CANADA REGULATIONS
NOTICE: The
Industry Canada
label identifies certified equipment. This certification means that the equipment meets
certain telecommunications network protective operational and safety requirements. The Department does not guarantee
the equipment will operate to the user's satisfaction.
-
Before installing this equipment, users should ensure that it is permissible to be connected to the facilities of the local
telecommunications company. The equipment must also be installed using an acceptable method of connection. In some
cases, the company's inside wiring associated with a single line individual service may be extended by means of a certified
connector assembly (telephone extension cord). The customer should be aware that compliance with the above conditions
may not prevent degradation of service in some situations.
- Any repairs or alterations made by the user to this equipment, or equipment malfunctions, may give the
telecommunications company cause to request the user to disconnect the equipment.
-
Make sure that the electrical ground connections of the power utility, telephone lines and internal metallic water pipe
system, if present, are connected together.
-
CAUTION
: The installation of this equipment should only be undertaken by qualified personnel.
-
The Load Number (LN) assigned to each terminal device denotes the percentage of the total load to be connected to a
telephone loop which is used by the device, to prevent overloading. The termination on a loop may consist of any
combination of devices subject only to the requirement that the total of the Load Numbers of all the devices does not
exceed 100.
Load Number for TPI-100 = 8
