P83439 B
Sheet 2 of 4
1.
Attach the 4 male PCB standoffs to the 4 mounting holes in the Single Circuit SAFEPATH PCB cover (see Figure 1) by pushing
standoff into the hole until it locks into place as shown in Figure 2.
2.
Place the Four Zone Splitter PCB on to the threaded stud portion of the PCB standoffs so that the studs mate with the mounting
holes on the PCB as shown in Figure 2.
3.
Attach the hex standoffs to the PCB standoffs to secure the PCB to the Single Circuit SAFEPATH PCB cover.
4.
Attach the Four Zone Splitter cover to the hex standoffs using the 4 mounting screws.
MOUNTING SCREW (4)
FOUR ZONE SPLITTER COVER
(FLANGE FARSIDE)
HEX STANDOFF (4)
TERMINAL BLOCK WIRE ENTRY
FOUR ZONE SPLITTER PCBA
PC BOARD STANDOFF (4)
SAFEPATH PCB COVER
VIEW FROM
BOTTOM SIDE OF UNIT
Figure 2.
WIRING INSTRUCTIONS:
1.
See Figure 3 for wiring diagram.
2.
See Figure 4 or the Four Zone Splitter cover silkscreen for terminal block wiring designations.
SYSTEM
POWER
SC SAPE
MAIN BOARD
ALL CALL
+
-
+
-
24V
+
-
AUDIO
+
-
+
-
+
-
ALL CALL
PWR
AUD
+
-
+
-
+
-
+
-
21
22
23
24
10K
END OF LINE
RESISTOR (EOLR)
Figure 3.
WIRING SPECIFICATIONS:
Cable
Size: 14-22
AWG
