background image

P83601 F 

Sheet 10 of 11

 

CAUTION: 

 If these appliances are operated within 15 inches of a person's ear, they can produce a sound pressure level that 

exceeds the maximum 120dBA permitted by ADA and OSHA rules.  Exposure to such sound levels can result in damage to a person's 
hearing. 
 
NS4-24110W strobe models are Listed for use in sleeping or non-sleeping areas when installed in accordance with appropriate NFPA 
Standards and the Authority Having Jurisdiction. 

 

WARNING:  INSTALLATION OF WHEELOCK 110 CANDELA STROBE PRODUCTS IN SLEEPING AREAS 

SHOULD BE WALL MOUNTED AT LEAST 24" BELOW THE CEILING  AS FOLLOWS:  (1) THE ON AXIS 
(DIRECTLY IN FRONT OF LENS) LIGHT OUTPUT SHOULD BE DIRECTED AT THE EYE-LIDS OF THE SLEEPING 
PERSON, E.G. PILLOW END OF BED, BED HEAD; (2) NO PART OF THE BED SHALL BE MORE THAN SIXTEEN 
(16) FEET FROM THE STROBE NOTIFICATION APPLIANCE.  INSTALLERS MUST ADVISE OWNERS AND 
OPERATORS OF BUILDINGS WITH SLEEPING OCCUPANTS, E.G. HOTELS AND MOTELS, TO WARN GUESTS, 
RESIDENTS AND EMPLOYEES TO NOT MOVE THE BED LOCATION TO A POSITION VIOLATING POINTS (1) 
AND (2) ABOVE OR SERIOUS INJURY AND/OR LOSS OF LIFE MAY OCCUR DURING A FIRE EMERGENCY. 

 

WARNING: A SMALL POSSIBILITY EXISTS THAT THE USE OF MULTIPLE STROBES WITHIN A PERSON'S 

FIELD OF VIEW, UNDER CERTAIN CIRCUMSTANCES, MIGHT INDUCE A PHOTO-SENSITIVE RESPONSE IN 
PERSONS WITH EPILEPSY.  STROBE REFLECTIONS IN A GLASS OR MIRRORED SURFACE MIGHT ALSO 
INDUCE SUCH A RESPONSE.  TO MINIMIZE THIS POSSIBLE HAZARD, WHEELOCK STRONGLY RECOMMENDS 
THAT THE STROBES INSTALLED SHOULD NOT PRESENT A COMPOSITE FLASH RATE IN THE FIELD OF VIEW 
WHICH EXCEEDS FIVE (5) Hz AT THE OPERATING VOLTAGE OF THE STROBES. WHEELOCK ALSO 
STRONGLY RECOMMENDS THAT THE INTENSITY AND COMPOSITE FLASH RATE OF INSTALLED STROBES 
COMPLY WITH LEVELS ESTABLISHED BY APPLICABLE LAWS, STANDARDS, REGULATIONS, CODES AND 
GUIDELINES. 
 
NOTE:  

NFPA 72/ANSI 117.1 conform to ADAAG Equivalent Facilitation Guidelines in using fewer, higher intensity strobes within 

the same protected area. 

 

CAUTION:  

Check the installation instructions of the manufacturers of other equipment used in the system for any guidelines or 

restrictions on wiring and/or locating Notification Appliance Circuits (NAC) and notification appliances.  Some system 
communication circuits and/or audio circuits, for example, may require special precautions to assure electrical noise immunity (e.g. 
audio crosstalk). 

 

NOTE:

  This equipment has been tested and found to comply with the limits for a Class B digital appliance, pursuant to Part 15 of the 

FCC Rules.  These limits are designed to provide reasonable protection against harmful interference in residential installation.  This 
equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, 
may cause harmful interference to radio communications.  However, there is no guarantee that interference will not occur in a 
particular installation.  If this equipment does cause harmful interference to radio or television reception, which can be determined by 
turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:  
1) Reorient or relocate the receiving antenna,  2) Increase the separation between the equipment and receiver,  3) Connect the 
equipment into an outlet on a circuit different from that to which the receiver is connected, and  4) Consult the dealer or an 
experienced radio/TV technician for help. 

 

The Series NS4 products and these instructions are copyrighted by Wheelock and the Series NS4 products contain proprietary, 
confidential and trade secrets of Wheelock.  No part of the Series NS4 products and these instructions may be photocopied, printed or 
reproduced in any form or modified, adapted, changed or enhanced, or converted to another programming language, or used to create 
updated, related or derivative works, without the prior written consent of Wheelock.  No part of the Series NS4 products shall be 
decomposed, disassembled or reverse engineered. 

 

ANY MATERIAL EXTRAPOLATED FROM THIS DOCUMENT OR FROM WHEELOCK MANUALS OR OTHER 
DOCUMENTS DESCRIBING THE PRODUCT FOR USE IN PROMOTIONAL OR ADVERTISING CLAIMS, OR FOR 
ANY OTHER USE, INCLUDING DESCRIPTION OF THE PRODUCT'S APPLICATION, OPERATION, INSTALLATION 
AND TESTING IS USED AT THE SOLE RISK OF THE USER AND WHEELOCK WILL NOT HAVE ANY LIABILITY 
FOR SUCH USE. 

 

IMPORTANT:  READ SEPARATE "GENERAL INFORMATION" SHEET FOR INFORMATION ON THE 
PLACEMENT, LIMITATIONS, INSTALLATION, FINAL CHECKOUT, AND PERIODIC TESTING OF NOTIFICATION 
APPLIANCES. 

Summary of Contents for NS4-121575W*












Reviews: