Getting Ready
AwARNING
Before cutting or threading pipes, be sure to check the following. If anything is out of the ordinary, consult the Troubleshooting
table and take the appropriate action as noted in the table. Failure to check and resolve problems may result in accident or injury.
8.Pre-Operational Inspection
(1) Set the switch to the ON position and step on foot
switch.
·
Make sure there is no abnormal noise or odor coming from the motor.
·
Make sure the pipe is not vibrating. If the pipe is vibrating, etc., fasten it in
place again.
·
Make sure cutting oil is coming out of the die head, and check that the
machine is filled with the correct amount of threading oil.
(2) Let the machine idle Jar a few minutes.
·
Make sure the motor does not heat up excessively, etc.
AwARNING
1 .Always use the recommended type of carbon brushes.
·
The brake may fail to operate if other carbon brushes are used.
2.Store the unit where it will not be subjected to excessive humidity.
·
Storing the unit in a humid location for long periods of time may cause an oxide film to form on the motor and prevent the brake from
operating properly. Always store the unit in a place with low humidity.
-
11
-
