4
•
Tilt the carrier to the ground using Pull Pin-A. Roll the chair into the carrier so rear wheels are
contained in the large wire form saddle. Tip the chair and carrier forward until Pull Pin-A snaps
back into position.
•
Secure the front wheels with the strap provided. Do this by putting the strap over or through the
front wheels. Make sure that both sides of the strap are secure. Double check the pull pin to
make sure it has snapped back into position.
•
Insert the end of the Hold Down Arm into the base. The prongs of the Arm should be over the
back wheel of the chair. Insert the Securing strap hook over the 1” tubing. Pull the strap tight.
Do not over tighten the strap. This may cause the wheel to warp.
FRONT WHEEL ADJUSTMENT
After loading your chair into the carrier, slide the front saddle to the position that fits your chair.
Tighten the Bolts to secure the front saddle.
IMPORTANT:
Always verify that the wheelchair is secure before operating the vehicle.
When not in use, the Tilt ‘N’ Tote can be folded up toward the bumper of the vehicle in its’ “stow away”
position.
•
The carrier tilts up to the “stow away” position by pulling Pull Pin-B and rotating the carrier up
toward the vehicle.
•
Make sure that Pull Pin-B snaps into the locking position and that the carrier is secure when in the
“stow away” position.
•
The Hold Down Arm can be left in base with the securing strap fastened down, or removed to
store in trunk for storage.
Operation Instructions
Storing the Carrier
Carrying
Position
Stow Away Position
[Not available on
the Model 003 tote]
