Wheatstone SP-8, Technical Manual

Page: 127 / 128

SP-8 / Dec 98
A
PPENDIX
The SP-8 furniture leg set is shipped in four sections:
a) two wooden side pieces
b) a front panel
c) a rear panel
Note the leg set has already been pre-assembled with the SP-8 console
at the factory, so all holes have been predrilled. The set is subsequently
broken down for shipping purposes. All that remains at the client end is re-
assembly.
a) Note the wooden side pieces: the curved edges face towards the front; metal
brackets have been pre-mounted on their inside surfaces; the bottom edge of each
piece is longer than the top edge. When set upright in the correct orientation, the
distance between them will equal the width of your SP-8 audio console, and the
front and rear vanity panels will span that distance.
b) The front vanity panel has its formica surface facing to the front; the cherry
strip is its bottom edge and rests on the floor.
c) The rear vanity panel has its formica surface facing to the rear. The cherry
strip is its bottom edge; when in place it leaves a 3/4” gap between it and the
floor. This is for wiring cable access.
FIELD ASSEMBLY CONSISTS OF FIVE BASIC STEPS:
1) Position the two side pieces and mount the FRONT VANITY PANEL
to them, by screwing through the side piece front metal brackets directly into
the predrilled holes on the front panel’s surface, using the wood screws
provided.
2) Mount the REAR VANITY PANEL to the rear metal brackets of the
side pieces. Note this panel is attached using finished cupwasher screws that
go into pre-tapped holes on the side pieces’ rear metal brackets. Remember
there will be a 3/4” gap between the rear panel’s cherry trim strip and the
floor.
3) With all screws tightened and the leg set safely assembled as a squared
rigid structure, it is time to place the SP-8 console onto the leg set.
When properly in position (see drawing next page) the console’s
wooden endpieces will rest on the leg stand’s side pieces, and will span the
rear vanity panel. Front to rear position is determined by the predrilled holes
in the bottom of the console’s mainframe.
4) With the console in place and properly positioned, remove the REAR
VANITY PANEL. This will allow you to get inside the leg stand and screw
up through the wooden flange on top of the front vanity panel into the bottom
of the console mainframe.
Appendix Page - 6
Refer to the drawing
on the next page
FURNITURE LEG SET ASSEMBLY INSTRUCTIONS