Section 4 - Electrical System
320 Outrage-Owner’s Manual
Ignition Shutdown Switch
The 320 Outrage is equipped with an ignition shut-
down safety switch. It is located on the lower center
section of the console. The ignition shut down safety
switch incorporates a shut-off switch, switch clip,
lanyard and lanyard clip, which is clipped to the op-
erator. If an emergency arises where the engine(s)
must be shut down, a pull on the cord to release the
clip from the shut-off will shut down the engine.
This switch is designed to shut the engine(s) off when
the operator of the boat leaves the control station,
either accidentally by falling into the boat, or by be-
ing ejected overboard. This would most likely occur
as a result of poor operating practices.
This switch only works when properly used.The de-
cision of whether to use an ignition safety switch or
not rests with you, the owner/operator.
It is advised that you wear your lanyard at all times
while operating the boat. It is for emergency stopping
only. Do not use it to shut off the engine during normal
operation. The lanyard should be long enough to pre-
vent inadvertent activation.
CAUTION
Ignition Shut-down
Switch
IgnitionShut-down
Switch Plate
Lanyard
(The lanyard shown in
this view is shorter than
actual, and is for reference
only).
Ignition Shut-down
Switch Clip, (attaches to switch)
Ignition Shut-down
Switch Clip,(attaches to you)
The decision to use the safety switch is up to you, the
owner/operator.
NOTICE
!
!
Electric Downrigger Receptacles,
(Optional)
The location for mounting of the downrigger base is
important, refer to the wood location diagram for ar-
eas on the gunwales that are specifically designed for
withstanding the stress generated by a downrigger.
There are a variety of downrigger mounting base plates
that can be used, it is important that you consult with
your salesperson to find the mounting base that will
best suit your application.
CAUTION
There are storage cradles designed for holding the
downrigger weights when not in use. Because of the
variety of weights available these cradles are designed
to hold the most common weights used.
NOTICE
!
!
30 Amp/12V
Receptacle/
Cover
Plug, (supplied in
downrigger kit)
Downrigger
Weight Cradle
The 320 Outrage can be fitted with two (2) electric
receptacles for powering electric downriggers. The
receptacles are located inside the cockpit on the aft
section of the port and starboard gunwales and are
rated to 30 Amps. Push the plug into the receptacle
and turn clockwise to secure the connection. There
is a “Port 12V Power” and Starboard 12V Power”
breaker on the Main Distribution Panel(MDP) in the
console interior. Should there be any interuption in
power, check here first. The receptacles are protected
by a weatherproof cover. There areas on the gunwales
that are designed specifically for downrigger mount-
ing bases. See your “Wood Location Diagram” for
proper mounting.
27
