v
v
3
ASSEMBLY INSTRUCTIONS
v
1
Step 1:
Mark wall for vanity placement and note the location of the
water supply lines and drain on the back panel of vanity.
2
Step 2:
Move vanity (B) into proper place against the wall.
3
4
ASSEMBLY INSTRUCTIONS
v
4
v
6
v
5
Step 3:
Install faucet, drain and supply lines (none included) to
vanity top (A) according to the instructions supplied with
those items.
A
Step 4:
In case of uneven floors, floor levelers are provided at the
bottom of the vanity. If necessary, adjust floor levelers by
hand to correct tilting and/or level doors.
Step 5:
To mount the backsplash (C) to the wall, apply a thin bead
of silicone compound (not included) to the unpolished
back side and bottom of the backsplash (C). Position
backsplash (C) as shown onto vanity top (A) and against
the wall. Clean any excess silicone compound before
allowing to dry.
Step 6:
Note: The adjustable shelf is pre-installed for shipping.
If the shelf position is not to your liking, you will need to
reposition the shelf by following the steps below:
a.
Look under the shelf, and locate the wood screws
holding the shelf to the shelf supports.
b.
Remove the wood screws from each shelf support with a
Phillips screwdriver (not included).
c.
Remove the adjustable shelf from the vanity (B).
d.
Remove the shelf supports from the vanity (B) and
re-position them in the desired location. Make sure you
place the shelf supports in the same level so the shelf is
not tilted.
e. Place the adjustable shelf back onto the shelf supports.
f.
Using the Phillips screwdriver, reinstall the wood screws
through the shelf supports and into the shelf.
B
B
A
C
UP
Silicone