6
Assembly Instructions
1.
Unpack the unit and confirm that you have all the hardware and required parts. Assembly the unit on a
carpeted floor or empty carton to avoid any scratch.
2.
Lay out the Top Panel (A), Fixed Shelf (B), Bottom Panel (C), Left and Right Side Panels (D and E)
with the holes facing up. Securely screw the Cam Bolts (2) into the designated small holes as shown in
the illustration.
3.
Glue one Wood Dowel (3) into the center hole on the upper edge of Upper Partition (H). Tap in with a
rubber mallet, if necessary.
NOTE: The upper edge of Upper Partition (H) has two cam lock holes running against. It is very
important to use a small amount of glue on both ends of dowels.
4.
Align the cam lock holes on the Upper Partition (H) with the installed Cam Bolts (2) on the Top Panel
(A) and press them together. Fasten the Upper Partition (H) in place by engaging two Cam Locks (1)
(Refer to page 3 on Cam Lock system operation supplement).
A
C
2
B
D
E
A
H
1
3