Model # ECOM-KCH
Please call for replacement parts or assistance:
1-866-942-5362
Whalen Furniture Manufacturing
Page 5
Factory No. 16936
Assembly Instructions
5.
Position last assembly upside down on a support surface, as shown.
NOTE
: Place a protective cover (like the bubble wrap packing material) over the carton or other support
surface to prevent from scratching.
6.
Remove the plastic caps from the hanger bolts of Front Legs (C). Attach 2 Front Legs (C) to the front
corner blocks of the Seat Frame (B) by inserting the pre-attached hanger bolts through the drilled holes
on corner blocks, and fit the Flat Washer (4), Lock Washer (3) and Hex Nut (5) onto each hanger bolt.
Tighten the Hex Nuts with the provided Open Wrench.
NOTE
: DO NOT fully tighten all the nuts until the chair has been adjust and level all the legs so that
they do not wobble. Once adjusted then go back and tighten while making sure that the unit remains level.
7.
Stand the assembled chair upright on a flat surface. Press down the Seat (B) to even all legs. Now,
tightly fasten all bolts and nuts with the provided Allen Wrench and Open Wrench.
A
C
C
B
3
4
5
B
C
C
Ø5/16” Hex Nut
(4 used in this step)
⑤
Lock Washer
(4 used in this step)
③
Flat Washer
(4 used in this step)
④
