Model # AVH-1
Please call for replacement parts or assistance:
1-866-942-5362
Whalen Furniture Mfg., Inc.
Page 7
Factory No. 16086
Assembly Instructions
3. Using the pilot holes as a guide, attach 2 Magnetic Catches (8) to both sides of the Divider
Panel (H) with four 5/8” Wood Screws (7). Tighten the screws with a Phillips screwdriver.
Make certain the magnetic plates point towards the front of the unit. See detail #2.
4. Insert 2 Wood Dowels (3) into the large holes pre-drilled on the bottom edge of Divider
Panel (H) as a guide. Tap in with a rubber mallet, if necessary. Make sure that you use a
small amount of glue on both ends of all dowels.
5. Align and attach the Divider Panel (H) to the Bottom Panel (D) using two 2” Wood Screws (5)
as shown in detail #2A. Make sure the magnetic plates face the front of the unit (the side
with cutouts is front). Securely tighten with a Phillips screwdriver.
6. Tightly screw the Center Support (J) into the threaded insert on the Bottom Panel (D). See
detail #2A.
Hardware required
Sketch
Qty.
(3) Wood Dowel
(2)
(5) 2” Wood Screw
(2)
(7)
5/8”
Wood
Screw
(4)
(8) Magnet Catch
(2)
Tools required:
Phillips screwdriver