Page 4 of 5
GENERAL SAFETY RULES
(continued)
OPERATION
EXTENSION CORDS
If an extension cord is being used, W. F. Harris Lighting, Inc.,
worklights require a three-wire extension cord. As the distance
from the supply outlet increases, you must use a heavier gauge
extension cord as shown at right. Using extension cords with
inadequately sized wire causes a drop in voltage, resulting in
loss of power and possible worklight malfunction.
• In order for the battery backup function to operate for the
maximum duration, the worklight must be plugged into a
120V receptacle for a minimum of 48 hours. The battery
will charge while the power switch is in the off position as
indicated by the charge indicator light.
• To operate the worklight in AC mode, plug into a 120V
60Hz standard receptacle and turn the switch on.
• For units equipped with a battery backup, the battery
backup feature is also controlled by the power switch. If
the power switch is in the off position, the battery backup
feature is also off.
• Use caution when attaching worklight to mounting
surface. Do not put fingers between worklight and wall
when mounting.
• Do not store your worklight in a damp or wet location. Do
not store in locations where the temperature is less than
32°F or more than 100°F. Do not store worklights in
vehicles or in outside sheds.
MAINTENANCE
Prior to performing any maintenance operation, the power cord must be disconnected and secured.
WARNING!
!
Upon removal, cover the battery pack’s terminals with heavy-duty adhesive tape. Do not attempt to destroy or
disassemble battery pack or remove any of its components. Nickle-cadmium batteries must be recycled or disposed of
properly. Also never touch both terminals with metal objects and/or body parts as short circuit may result. Keep away
from children. Failure to comply with these warnings could results in fire and/or serious injury.
WARNING!
!
CLEANING
• The lens and housing may be cleaned with a soft cloth
using mild soap solution.
• Commercially-available cleaning products that are
specifically formulated for cleaning polycarbonate may
also be used.
• Care should be exercised to ensure that any dirt or grime
on the lens not be permitted to scratch the lens.
•Avoid using sprays directly on the housing of the
product. Always lightly spray the cloth then wipe the
worklight.
BATTERY REPLACEMENT
• The battery is replaceable. Only qualified technicians
should perform battery replacement. Contact
W. F. Harris Lighting, Inc. Customer Service for
information at 800.842.9345 or e-mail
[email protected].
• Battery disposal shall be in compliance with any local
regulations that address the disposal of hazardous
materials.
• Do not incinerate.
Part Number IMS90300-9AI
IMPORTANT SAFETY INSTRUCTIONS
The use of these worklights requires an understanding of the information on the product and in this Operator’s Manual.
Before use of this product, familiarize yourself with all operating features and safety rules.
WARNING!
!
WORKLIGHT CORD MINIMUM
TYPE LENGTH AWG
STANDARD < 100 FT 18 AWG
STANDARD 100 FT - 150 FT 16 AWG
STANDARD > 150 FT NOT RECOMMENDED
