BDA UP 14 ZLW
– 4481N16000 – 09/16 – REV. C
Page 38 / 51
4.5
Release Button
In case of jammed jaws caused by operation
or handling errors or wrongly placed
terminals the jaws can be opened as follows:
+
Press Release Button.
5
Transport and Installation
5.1
Transport
The weight of the pneumatic Crimp Machine UP 14 ZLW is approx. 14 kg (31 lbs).
CAUTION
+
Wear suitable safety shoes when transporting the machine.
ATTENTION
+
Pneumatic tubes must not be damaged.
5.2
Installation
ATTENTION
+
Position the pneumatic Crimp Machine UP 14 ZLW on a flat surface and assure the
stability of the machine. Ensure that the table or bench is stable enough to support the
machine in normal use.
+
Assure an appropriate table height. The table height is dependent on the position of the
operator, (work in sitting or standing position) according to prEN 894-4:2004, Table A.1.
+
Assure appropriate illumination of the working place. (EN 1837:2009-12
– chapter 4.2: “The
general value of illumination has to be 500 lx [...]").
INFORMATION
+
To reduce production noise or vibration, the machine can be placed on an insulating rubber
mat.
Place the foot pedal on the floor. No other place is allowed!
ATTENTION
+
Place the tubes on the floor or out of the way so that they do not cause a trip hazard.
+
Do not lay the foot pedal in aisles or walkways.
+
Assure free access to the operating elements of the machine, especially the foot pedal
and the release button.
+
Wear suitable safety shoes when transporting or installing the machine.
INFORMATION
+
To ensure fatigue-proof use, the user has to take a working position, where the machine is
at the right height and the foot pedal is accessible. The foot pedal has to be installed in a
stable position. The position of the foot pedal should be chosen in that way, that free
access will be possible.
Fig. 4.1
