Wexxar WF30T, Operation And Service Manual

Page: 18 / 190

WF30T Case Former Installation
2-5
2 INSTALLATION
2.1 Prerequisites
To install the WEXXAR WF30T Case Former you will require:
•
A forklift truck and four (4”x4”) wooden blocks to remove the machine from the skid.
•
A spirit level to level the machine.
•
Compressed air and electrical power supplies.
The preferred method to remove the machine from the base is by means of a forklift. Use
appropriate wood blocking (i.e.: 4 pieces of 4” x 4” x 12” timber) to block protruding parts.
2.2 Site Environment Consideration
Before receiving the machine, consider the physical environment that the machine will operate in.
Consider the following factors before transporting, unpacking, installing, or setting up the
machine.
•
The machine operator is required to guarantee that the temperature and humidity values
of the site into which the machine will be installed meet the required and published
manufacturer specifications in Section 11.1. The machine should be installed within the
range allowed by these specifications.
•
This machine is intended for use in a controlled indoor environment free of conductive
contaminants.
•
Do not let the any areas of the unit adjacent to electrical components come in contact
with water.
•
Do not stand beverage containers on the electrical panel, or on any surface adjacent to
electrical components.
•
This system is not intended for external use unless it has been specifically modified for
that purpose.
•
This unit is rated in accordance with national and local electrical codes. Make sure that
the power connection is also wired to these specifications.
•
The power supply for this unit:
1. Must be rated in accordance with the equipment data plate.
2. Must be suitably grounded.
•
Do not place the machine near any heat source or machinery which may produce
metallic particles, dust or powder. Do not place the machine near equipment that will
produce corrosive substances or vapor.
•
Walls, ceilings, floors, or anything near to the machine should be constructed of
noncombustible materials. A portable fire extinguisher should be accessible nearby.
•
Do not place the machine below the shower of a fire extinguishing system.
•
Do not locate in an area where unauthorized personnel may have access to the unit.
•
Install the unit in a well-ventilated area away from flammable liquids, gases, and
explosives.