7
Headset / changing of batteries (see image):
The battery compartment (6) is right below the volume
control.
Push against the cover from the right side and then swing
it outwards.
Put the 2 batteries (LR06, AA) in the battery compartment
according to the polarity mark.
Swing the cover back to close the compartment (at the
same time putting to the left) and then press it again to the
right into the locking device.
Take the batteries out of the headset, if you do not use it
for some time.
Replaying of the audio source:
Make sure, that the transmitter is connected as described in the previous chapter
and that your audio source is in replay mode.
First adjust the volume of your audio source to a medium level.
Adjust the volume on your headset with the volume control (7) to a medium level.
Turn on your headset with the On/Off switch (10). The operating indicator (9) lights.
Put on the headset and adjust it to fit to your head. For that purpose, both loud-
speakers are height adjustable on the holder. Thereby they offer a customized
wearing comfort.
You can adjust the headset (receiver) with the adjustment control (8) to the signal of
the transmitter. Turn the control slowly in order to receive any channel. You can
hear the signal of your audio source, if the signal is adjusted correctly.
Adjust the volume control (7) to a comfortable level.
Tips and Troubleshooting
9
If the volume is not sufficient or the sounds is not as desired, you can change the
sound settings on your audio source as well.
9
Poor reception and dropouts show that the batteries must be renewed or the accu-
mulators must be charged.
9
According to the position of the wireless headset a range limitation because of walls
or other obstacles could occur. In this case, try to vary the position of the transmitter
or the headset.
9
Other radio signals operating on the same band could disturb the operation. Turn
them off during using the headset, if possible.
Initial Setup and Operation
1.
2.
3.
