CONNECTIONS – STX MICRO-4
6
Wet Sounds STX MICRO Series Amplifiers Operations / Installation Manual
BEFORE ANY INSTALLATION IS BEGUN – DISCONNECT THE BATTERY!
8. Power (RED) Connection.
It is recommended that the power connection
be run directly to the vehicle’s battery. Run a minimum 8 Gauge wire with
a fuse at the battery. Be sure that the outboard dual ATC fuse holder stays
close to the amplifier. FAILURE TO USE THE SUPPLIED OUTBOARD FUSES IN
THE INSTALLATION IS DANGEROUS AND WILL VOID THE WARRANTY!
9. Ground (BLACK) Connection.
This should be connected to chassis ground
where possible. If the vehicle does not have a chassis ground, run a wire
directly to the negative side of the battery.
10. Remote Turn-On (BLUE) Connection.
This should be connected to a wire
that su12V when powered on. The BLUE wire must r12V
for the amplifier to power on.
11. Speaker Connections.
Speaker connection color codes are as follows:
Front Left Positive Speaker
White (Bridged Front +)
Front Left Negative Speaker
White / Black
Front Right Positive Speaker
Grey
Front Right Negative Speaker
Grey / Black (Bridged Front -)
Rear Left Positive Speaker
Green
(Bridged Rear +)
Rear Left Negative Speaker
Green / Black
Rear Right Positive Speaker
Violet
Rear Right Negative Speaker
Violet / Black (Bridged Rear -)
12. Front and Rear Inputs.
Connect to the output of the source unit or BT
controller. These connectors are designed to accept a 3.5mm male plug.
An RCA style adaptor such as the Wet Sounds WW-RCA-3.5mm 2ft can be
used if the source has RCA style connectors.
13.Pass Through Output.
Use this output if you need to feed signal to the
input on an additional amplifier – such as the STX MICRO-1 or a Wet
Sounds ST-AS10/AS6 amplified subwoofer. This will pass the same signal
that is present at the front input, avoiding the need for any Y adaptors.
