![background image](http://html1.mh-extra.com/html/wet-sounds/stealth-6-core/stealth-6-core_user-manual_966500004.webp)
3.
LIMITED WARRANTY
How to Obtain Warranty Service
Contact Wet Sounds, Inc. either by phone at 877-938-7757 or by email at
[email protected]. A service representative will assist you in the
necessary actions to verify that the problem that you are experiencing is covered
under warranty. If it is in fact a warranty issue, Wet Sounds will issue an RA
number for tracking purposes and give instructions on sending the product in for
evaluation. Wet Sounds™, Inc. How State Law Applies This warranty gives you
specific legal rights, and you may also have other rights which vary from
state to state.
Internet Warning
Wet Sounds, Inc. products sold on any non authorized web site or internet
auction site are void of any and all manufacturer’s warranty. Please contact
Wet Sounds™ at 877-938- 7757 or visit our web site at www.wetsounds.com to
search for an authorized site and/or an authorized retailer near you.
Caution & Respect
Wet Sounds™ speakers can achieve very high sound pressure levels. Please
use this product responsibly. Be aware that sound travels great distances so
please respect others. Wet Sounds, Inc. is not responsible for any violations of
the law that may be a direct result of excessive volume. Please abide by the rules
but have fun doing it.
INSTALLATION
A. Instructions
1.
Fit the appropriate tube clamp around the front strut in the desired location.
*Note: you may need to remove bolts connecting the top to the front
strut to complete this step.
2.
If a sliding adapter was supplied in your kit, you will need to loosely fasten it to
the soundbar, and then to the round tube clamps installed in step 1.
3.
Ensure that the sound bar is in the desired location, then tighten all hardware.
B. Wiring
1.
Carefully remove the Positive (+) then Negative (-) battery wires.
2. A. If installing on a gas vehicle,
wire the Negative (Black) wire to the
Negative (-) battery terminal and the Positive (Red) wire to the Positive (+)
battery terminal.
B. If installing on an electric vehicle,
wire the Negative (Black) wire to the
Ground on the DC-DC Converter and the Positive (Red) wire to the Positive
(+) post on the DC-DC Converter.
3.
Route the blue Aux wires to a desired location.
4.
Tie up all excess wires and reinstall the Positive (+) then Negative (-) battery
wires.
C. Electric Vehicles
1.
Switch it into TOW MODE under the seat.
2.
On the very last step, switch back to RUN MODE.
Note: DC-DC Converter is required on electric vehicles to avoid damage to
the accessory and the vehicle.