3
OPERATION and INSTALLATION
Wet Sounds REVO 6 / REVO 8 Marine Coaxial/Full Range Speaker Systems
OPERATION and INSTALLATION
Please review the hole cut out dimensions for REVO6 and REVO8 speakers
and make sure that the correct and appropriate opening is provided for
the speakers. Be sure to use the stainless steel screws that are provid-
ed. This will prevent against corrosion. Also included is a waterproof two
conductor connector to connect the speakers to the amplifier or source
unit. The red wire is positive, while the black wire is negative.
For removal and replacement of the tweeter:
1. Remove the grill from the speaker basket. There are 3 screws under the
rubber gasket around the speaker basket holding the grill on.
2. Unplug the tweeter wire from the plug that is fixed to the speaker basket.
Free the tweeter wire and the RGB LED wire from the grill.
3. Turn the tweeter in a counter-clockwise direction to detach it.
4. Remove the crossover cover from the rear of the speaker magnet by
depressing the 3 tabs on the back of the speaker. The RGB LED wires can
then be removed.
5. Insert the replacement tweeter in the socket & turn in a clockwise direction
until the tabs lock in place. Be sure to route the tweeter and RGB LED
wires through the slots on the underside of the grill.
6. Plug the tweeter wire into the plug provided on the speaker basket.
7. Route the RGB LED wire under the crossover cover & reattach the crossover
cover – taking care to route the wires through the slots provided in the
cover.
Special instructions about the RGB LED lighting behind the tweeter:
1. The RGB LED 4 wire harness should be connected with BLACK on +12V
(a 2A inline fuse is required to be added). The other 3 wires (RED, BLUE
& GREEN) can be combined & connected to ground (-12V) in a variety of
combinations to achieve one color of illumination behind the tweeter cup.
For instance – grounding RED & BLUE together will result in purple color.
2. Adding an LED controller like the Wet Sounds RF-RGB-MC V2 enables the
display of thousands of color combinations, as well as light changing
modes and the ability to change the lights with music – all controllable
via a hand held wireless remote.
