TM
Remove connector from packaging and disassemble.
See figure 1.
Strip the ends of the speaker wires.
Place Blue Threaded Collar (part A) onto speaker
wire. See figure 1.
Slide the clamping piece (part B) onto the speaker
wire. Black clamping piece is for larger wire, White
clamping piece is for smaller wire. See figure 1.
Attach the stripped ends of the speaker wires into the
screw down terminals on part C. The terminals are
labeled behind the screw heads. You will use 1+
and 1-. (see wiring diagram) 2+ and 2- will not be
used.
Once wires are attached slide Part D over Part C.
There are tabs that must be aligned. You will need to
rotate the parts. See figure 2.
Slide Part B into Parts C and D. There are also tabs
that must be aligned. You will need to rotate the
parts. See figure 2.
Thread Part A into Part D. Thread all the way down
so the connector is tight. See figure 3.
The connector inserts into the speaker by aligning
the tabs and a push and turn motion. Once inserted,
the metal tab will lock the connector into place. To
remove, pull tab back with thumb and rotate and
slide connector out. See figure 4.
3
