ASSEMBLY INSTRUCTIONS
Description
1. Insert the round-shaped steel side handle into the
slots of the plastic brackets.
2. Align the holes of plastic brackets with the rivet
nuts in the sides of the workstation.
OPERAITON FOR DRAWER
To remove the drawer:
To remove drawers, release the retaining clip by pushing the lever up on one side and
down on the other side simultaneously
Then pull the drawer out.
3. Insert a M8*60mm screw into each hole of the
plastic brackets.
4. Tighten all screws securely.
MAINTENANCE
Lubricate the lock with graphite annually. Lubricate the ball bearing slides with grease twice
annually.
Place the workstation casters up on a flat surface.
Protect the paint by placing the packaging down
first.
2. Insert the hex bolt M8*25mm into the
10*25*2mm washer, then through one caster
and into the bottom of the roller cabinet.
1.
3. Tighten all bolts by hand until the workstation is
assembled. Then, tighten the screws using a
wrench until you feel resistance. Do not over
tighten.
m
a
in
te
n
a
n
c
e
/
r
e
p
a
ir
S
a
fe
ty
/
S
p
ecif
ic
a
ti
o
n
s
ass
em
b
ly
/
in
s
t
a
ll
a
ti
o
n
G
e
tt
in
g
S
ta
r
te
d
o
per
a
ti
o
n
T
r
o
uble
S
h
o
o
tin
g
m
a
in
te
n
a
n
c
e
/
r
e
p
a
ir
ass
em
b
ly
/
in
s
t
a
ll
a
ti
o
n
S
a
fe
ty
/
S
p
ecif
ic
a
ti
o
n
s
T
r
o
uble
S
h
o
o
tin
g
o
per
a
ti
o
n
G
e
tt
in
g
S
ta
r
te
d
To install the drawer:
Extend the drawer slides from the Chest. Insert the brackets on each side of the
drawer into the slots in the chest slides, being careful that they are properly
positioned. Once properly inserted, completely close the drawer to set the slides
in their proper positions.
