ORDERING WITH
WESTLAB IS EASY
Online
www.westlab.com.au
Order online with our easy
Express Order form for fast,
secure ordering.
Phone
1800 385 101
Speak to one of our friendly,
efficient staff from
8.00am - 5.00pm (Mon/Fri)
24 hours, 7 days a week
convenience.
6
PRODUCT MANUAL
1800 358 101
www.westlab.com.au
+64 9 553 3677
www.westlab.co.nz
646 568 5391
www.westlab.com
1 877 822 1455
www.westlab.com
Australia
New Zealand
United States
Canada
4.2 Operation
1. Ensure the stainless-steel false base is fitted and fill the bath with water following Liquid
Level Instructions. SWITCHING THE BATH ON WHEN DRY WILL DAMAGE THE HEATER
AND MAY INVALIDATE YOUR WARRANTY.
2. Connect the mains power lead to an electrical supply.
3. Turn the bath on using the green mains power switch located on the front. Wait while the
controller loads, and temperature is displayed. You can now change the set point.
P
To Programme Set Point
▲
Up Arrow: To Increase Set Point Value
▼
Down Arrow: To Decrease Set Point Value
U
To Access Temperature Readings
4. Press the P key. Display will alternate between SP (set point) and the set value.
5. Use the UP and DOWN ARROW keys to adjust the value to the required temperature.
6. Press the P key to save and exit. Alternatively, the value will be saved, and the programme
exited if no key is pressed for 15 seconds.
7. Display will return to normal indicating actual temperature.
8. Amber heater indicator will illuminate to show heater activity.
9. Press the U key once to display lowest temperature Lt. The display will alternate between
Lt and lowest temperature in the bath during use.
10. Press the U key twice to display highest temperature Ht. The display will alternate
between Ht and highest temperature in the bath during use.
11. Press the U key three times to display the temperature probe reading Pr1. The display will
alternate between Pr1 and current water temperature. The controller will revert to actual
temperature when no keys are pressed.
ATTENTION: Do Not Stand Vessels Directly onto the Bath Base. Always use the False Base
or Shelf Otherwise Damage May Occur to the Heaters.
5. Product Disposal
In the case that the product is to be disposed of, the relevant legal regulations are to be
observed.
