17
INSTALLATION
WARNING
CAUTION
Do not hold or carry the appliance by the door handle.
The door handle is not designed to hold the weight of
the appliance and can be damaged.
1. Fully insert the appliance and center it in the
cabinetry. Do not kink the connecting cable.
2. Screw the appliance into place.
3. The gap between the worktop and the appliance
must not be closed by additional battens.
Specifications
Model:
TC944DH6-S10F
Rated Voltage
240V~50Hz
Rated Input Power (Microwave)
1650W
Rated Output Power (Microwave) 900W
Rated Input Power (Grill)
1750W
Rated Input Power (Convection)
1750W
Rated Input Power (Combination) 3350W
Turntable Diameter
360mm
External Dimensions (HxWxD)
454 x 595 x 548mm
Net Weight
Approx. 41 kg
WARNING
CAUTION
Do not block the air vents. If you do, the appliance
can overheat.
WARNING
CAUTION
Do not connect the appliance to adapters or extension
leads. This can cause overloading and risk of fire.
This appliance comes with a supply cord but no plug.
Electrical connection must be made by a qualified
electrician.
As stated in the local municipal building codes and other
relevant statutory regulations.
• Wiring connections must be in accordance with
AS/NZS 3000 Wiring Rules and any particular
conditions of the local authority.
• Refer to data plate for rating information and circuit
diagram. The data plate is positioned behind the
bottom of the oven door. The circuit diagram is
positioned on the top panel of the appliance.
• For appliances with open cooking surfaces, an all pole
disconnect functional switch should be provided near
the appliance in an accessible position. Refer to
AS/NZS 3000 clause 4.7.1.
• Wiring should be protected against mechanical
failure. Refer to AS/NZS3000 clauses 3.3.2.6, 3.9, 3.10.
• A means of disconnection with a contact separation
of at least 3mm must be supplied in the fixed wiring.
WARNING
WARNING
This appliance must be properly earthed.
• Do not lift the appliance by the door handle.
• Prepare the cupboard opening to match your
appliance measurements. (See diagrams).
• Slide appliance into the cupboard, ensuring that the
supply cable (where fitted) does not kink.
• To prevent tipping, use the screws supplied to secure
your oven into the cupboard. Use just 2 screws for
single cavity ovens.
• If the supply cord is damaged, it must be replaced
by the manufacturer or its service agent or similarly
qualified person in order to avoid a hazard. The plug
must be accessible after installation.
• Where the appliance is built into a cabinet, the
cabinet material must be capable of withstanding
70°C. Installation into low temperature tolerant
cabinetry (e.g. vinyl coated) may result in
deterioration of the coating by discolouring or
bubbling.
• If the appliance is installed adjacent to vinyl-wrapped
surfaces, use an installation kit available from the vinyl
wrap supplier.
