Westinghouse WHE5000, User Manual

Page: 14 / 20

14 Care & maintenance
CHANGING tHE LIGHt bULb
1 . Switch off the power at the power point and remove the
cord by pulling the plug .
2 . Carefully unclip the light cover by pulling the light cover
tab at the rear, towards you .
3 . Unscrew the light bulb and replace it with a new bulb
of the same type and wattage . If, when you remove the
light bulb the small rubber “O” ring comes out with the
bulb, fit the “O” ring over the new bulb and screw bulb
into the socket (see diagram at bottom of page).
WARNING
Never insert your finger into the light bulb socket to check
for the presence of the “O” ring .
4 . Replace the light cover by hooking the lugs into the front
of the housing and pressing the rear of the cover up until
it clips in .
5 . Wait 5 minutes to ensure pressures in the refrigeration
system are equalised, before turning the refrigerator on
at the power point .
TIPS & INFORMATION
Ensure the ‘o’ ring is in place before replacing the bulb.
Light bulb “O” ring Light socket
CLEANING tHE AppLIANCE
WARNING
Before cleaning: Turn appliance off at the power point, then
remove power cord from socket . This will make sure there is
no chance of getting an electric shock .
• Doors – stainless steel
This stainless steel has a special advanced protective
coating that eases the removal of marks such as
finger prints and water spots . To keep your stainless
steel appliance looking at its best, you should clean it
regularly . You should only clean the stainless steel doors
with luke-warm soapy water and a soft cloth, rinsing
with clean water and then wipe the surface with clean
water and a soft clean cloth to remove soap residue .
• Doors - cabinet & painted doors
An occasional wipe over with a clean, damp cloth will
help remove finger marks . You should only clean the
doors with lukewarm, soapy water and a soft cloth .
Rinse with clean water and then wipe the surface with a
soft, clean cloth to remove any soapy residue .
Note: only wash plastic parts or decorative trim with
warm (not hot) water using an unscented detergent.
CAUTION
Do not use stainless steel cleaners, abrasive pads or other
cleaners as they are likely to scratch the surface . Damage to
this product after delivery is not covered by your warranty .
• Interior
You should clean the appliance interior regularly . It will
be easiest to clean when the food supply is low . Wash
the interior with a soft cloth and use an unscented mild
soap with lukewarm water . Thoroughly dry all surfaces
and removable parts . Avoid getting water on appliance
controls . If you have taken out any removable parts,
replace them and switch the power on before re-
stocking the appliance with food . Naturally, you should
keep the interior of your appliance hygienic by promptly
and thoroughly wiping up any food spills .
Do not use a steam cleaner . If live components come
into contact with condensing steam, they may short-
circuit or cause an electric shock .
• Door seals
Take care to keep door seals clean . Sticky food and
drink can cause seals to stick to the cabinet and tear
when you open the door . Wash seal with a mild
detergent and warm water . Rinse thoroughly and dry .
CAUTION
Never use hot water, solvents, commercial kitchen cleaners,
aerosol cleaners, metal polishes, caustic or abrasive
cleaners, or scourers to clean this appliance, as they will
damage it. Many commercially available cleaning products
and detergents contain solvents that will damage your
refrigerator . When cleaning, use only a soft cloth with
an unscented mild soap and lukewarm water .
MAINtAINING YoUR REFRIGERAtoR