8
ENGLISH
QB025 8
Installation (continued)
- Place the stainless steel mounting bracket (H) on the brass
connector assembly and adhere upright to the wall .
-
Ensure that both arms of the bracket are aligned horizontally
with a carpenter’s level before proceeding . Adjust if needed .
- Secure and tighten the nut (J) on brass assembly using
1
or 2
of the stainless steel washers (G), if required, see Fig . 12 .
NOTE:
Bracket (H) allows for mounting this unit on flat walls or on walls that
have a shower surround or tiles with a step of up to 1-1/2" (38 mm).
Shower
Outlet
Brass
Connector
Assembly
G
H
J
Fig .12
- With a dry rag, clean the wall between the brass connector and
the shower valve .
-
Thoroughly clean a palm-sized area of the wall approximately
22.5" below the brass connector as shown in figure 13. Use
a clean dry rag and ensure all debris and residue is removed
from the wall surface . Use isopropyl alcohol if so required .
Shower Outlet
22 1/2
" (572 mm)
Clean Bracket
Mounting Area
Fig .13
- Layout bottom bracket (BB) mounting location by drawing
a “T” as shown in figure 13 and 13B in the bracket
mounting area .
- Use the bottom bracket (BB) to layout the location of the
screw holes as shown in figure 13C.
- Poke small holes in the double sided backing tape if needed
for easier marking .
Fig .13B
BB
Fig .13C